Schneider Electric 170AMM11030 manual Map, Analog I/O

Page 12

Analog I/O	The diagram below shows field wiring for analog input and analog output devices.
Devices

Row 2

AI2 AO1- AO2- M-

16-42 VDC

16-42 VDC Return

Row 3

Row 4

−

Analog Sensor

Analog Actuator

(Input Devices)

(Output Devices)

Recommended fuses:

F3: Use a 1A fuse, Wickman 19181-1A or equivalent.

I/O Map

I/O Map Module	The module must be I/O mapped as 8 contiguous input words and 8 contiguous
Configuration	output words.

12	31005009 01 November 2003

Image 12

Contents 170AMM11030 Analog/Digital Momentum I/O Base User Guide VersionSafety Information 170AMM11030 Analog/Digital Momentum I/O Base Front Panel ComponentsOverview Front PanelComponents of the I/O Module LED Illustration The illustration below shows the LEDsFollowing table describes the LEDs DescriptionsSpecifications SpecificationsGeneral Output is protected against short-circuiting and overloadTo ground Number of Channels Output Ranges Type of Signal Fault SensingFault Reporting Operating VoltagePhysical Dimensions Internal Pin ConnectionsTerminals on the I/O base and an optional busbar Field Wiring Guidelines Wiring Diagrams Discrete input and output analog input and outputDiscrete I/O DevicesMap Analog I/ORegister for Outputs Word FunctionWord Zero is an illegal value for the parameter field wordsDamage 4x Registers Words 4Register for Inputs RangeOutput Operating Range Input register is arranged as followsSet to an OFF state Discrete Input RegisterBits Description Words 3 Analog Input RegisterWords 5 Words 5 .. are not usedAnalog Map Input WordOutput Word Points are field wired to row Discrete I/O Points and IEC Compliant Data MappingInput and Output Ranges Ranges Decimal Values Input Measuring Range ±10Output Measuring Range ±10