Network Technologies SM-8X4-HDA operation manual Change Output Port, Change Input Port

Page 31

NTI AUDIO/HD VIDEO MATRIX SWITCH

Change Output Port

Press the desired port number. If there is no change in the desired output port, the output port must still be selected. As the digits are selected, the last number entered will blink. The LCD will also display the current switch number followed by the decimal point.

With the desired port number selected, point the IRT at the switch/receiver and press the "OUT" button to transmit the selection and make the change. The blinking number in the LCD will stop blinking. An LED on the receiver will illuminate.

FYI: If the switch did not receive the data the LED will not illuminate. The user can re-send the same data by pressing the "OUT" button again. The LED at the receiver will illuminate to indicate a completed transmission from the IRT..

Note: If the number introduced is larger than the maximum number of outputs the IRT is configured for, then once the "OUT" key is pressed the LCD will display the current switch and the error signal "EE".

Change Input Port

Press the desired port number. As the digits are selected, the last number entered will blink. The LCD will also display the current switch number followed by the decimal point.

With the desired port number selected, point the IRT at the switch/receiver and press the "IN" button to transmit the selection and make the change. The blinking number in the LCD will stop blinking. The LED at the receiver will go OFF.

FYI: If the switch did not receive the data the LED will not go OFF. The user can re-send the same data by pressing the "IN" button again. The illuminated LED on the receiver will go OFF when the received data is complete.

Note: If the number introduced is larger than the maximum number of inputs that the IRT is configured to control, then once the "IN" key is pressed the LCD will display the current switch and the error signal "EE".

27

Page 30 Page 32
Image 31
Page 30 Page 32
Contents SM-8X4-HDA Trademark Table of Contents Table of Figures Cables Default User Name and PasswordsIntroduction MaterialsFrontViewofVEEMUX-A Features and FunctionsConnect the Sources Installation+L- R+R Connect the DevicesConnect to the Ethernet Connect RS232Plug in and power up Power UpOutput user number can be entered Control OptionsFront Panel LCD with Keypad Control Escape back to the main display Used to enter numbers. #Saving Connections Volume ControlMemory Functions Menu ButtonScan Mode Unit Address RS232 ControlRemote Connection Baud RateCommand Good Response Description String Command ProtocolMain Options SerTest- RS232 Interface Test ProgramMatrix Operations Setup OptionsEthernet Operations Telnet Interface Command Reply DescriptionTelnet 192.168.1.1 NTI AUDIO/HD Video Matrix Switch Web Interface Enter the PasswordWeb interface Video Switch Video SwitchWeb interface Audio Switch Audio SwitchWeb interface Setup Setup PagesInput Names Web interface Serial SetupOutput Names Scan ModeWeb interface Update Firmware Update FirmwareLogout Change PasswordUpdate Web Server HelpDevice Discovery Tool Device Discovery ToolLCD Display Features And FunctionsInfrared Control KeypadChange the Switch How To Use The IRTPower on with SYS, in or OUT keys Power on with 2 key Change Input Port Change Output PortSet Configuration Replace slide cover on unit Battery ReplacementSpecifications Troubleshooting the IRTPinout of RS232 port on VEEMUX-A RS232 Connection CablesPinouts for typical DCE to DTE cable for CPU connection Pinout for Matrix Y-1 Cable Safety StatementsWiring Schematic of Matrix-Y-1 cable Arrows indicate signal directionMount the VEEMUX-A to a rack Rack Mounting InstructionsSpecifications Solution TroubleshootingWarranty Information Problem
Top Page Image Contents