Network Technologies SM-8X4-HDA operation manual Set Configuration

Page 32

NTI AUDIO/HD VIDEO MATRIX SWITCH

Set Configuration

The IRT-64x32 factory default setting is 32 inputs and 16 outputs. When the batteries are changed the setting will return to the default value. At the default setting the IRT has the ability control any matrix switch with up to 32 inputs and 16 outputs without changing the configuration. However, when controlling smaller switches without changing the configuration it is up to the user to press valid number(s). To avoid confusion, it is recommended to configure the IRT to communicate with the largest switch to be controlled.

To change the maximum number of inputs or outputs:

1.From power-down state (blank LCD) press and hold the "SYS" button for at least 3 seconds. The LCD will first display an error message but after 3 seconds the letter "c" will display:

2.Enter the number of inputs or outputs. As the digits are entered, they will be displayed and the last one entered will blink.

Note: Only the inputs OR the outputs may be configured each time the configuration function is used. To perform another configuration operation the user must start again at "Set Configuration" step 1.

3.Accept the choice by pressing the "IN" button for setting inputs, or the "OUT" button for setting the outputs. The LCD will not blink anymore and will display “i” (for inputs) or "o" (for outputs) and the number.

Notes:

-The maximum number of inputs and outputs that can be entered is 32 and 16 respectively. If the user introduces a number larger, the display will show an error signal ("c.EE") and the maximum number will remain at the last valid value configured.

-If more than one switch is being controlled, the IRT should be configured for the largest switch. It is up to the user to introduce valid numbers to the smaller switches when making selections.

28

Image 32
Contents SM-8X4-HDA Trademark Table of Contents Table of Figures Default User Name and Passwords IntroductionMaterials CablesFeatures and Functions FrontViewofVEEMUX-AInstallation Connect the SourcesConnect the Devices +L- R+RConnect RS232 Connect to the EthernetPower Up Plug in and power upControl Options Front Panel LCD with Keypad ControlEscape back to the main display Used to enter numbers. # Output user number can be enteredVolume Control Memory FunctionsMenu Button Saving ConnectionsScan Mode RS232 Control Remote ConnectionBaud Rate Unit AddressCommand Protocol Command Good Response Description StringSerTest- RS232 Interface Test Program Main OptionsEthernet Operations Setup OptionsMatrix Operations Telnet 192.168.1.1 Command Reply DescriptionTelnet Interface NTI AUDIO/HD Video Matrix Switch Enter the Password Web InterfaceVideo Switch Web interface Video SwitchAudio Switch Web interface Audio SwitchSetup Pages Web interface SetupWeb interface Serial Setup Input NamesScan Mode Output NamesUpdate Firmware Web interface Update FirmwareChange Password Update Web ServerHelp LogoutDevice Discovery Tool Device Discovery ToolFeatures And Functions Infrared ControlKeypad LCD DisplayPower on with SYS, in or OUT keys Power on with 2 key How To Use The IRTChange the Switch Change Output Port Change Input PortSet Configuration Battery Replacement SpecificationsTroubleshooting the IRT Replace slide cover on unitPinouts for typical DCE to DTE cable for CPU connection RS232 Connection CablesPinout of RS232 port on VEEMUX-A Safety Statements Wiring Schematic of Matrix-Y-1 cableArrows indicate signal direction Pinout for Matrix Y-1 CableRack Mounting Instructions Mount the VEEMUX-A to a rackSpecifications Troubleshooting Warranty InformationProblem Solution