Network Technologies SM-8X4-HDA Rack Mounting Instructions, Mount the VEEMUX-A to a rack

Page 36

NTI AUDIO/HD VIDEO MATRIX SWITCH

RACK MOUNTING INSTRUCTIONS

This NTI switch was designed to be directly mounted to a rack. It includes a mounting flange to make attachment easy. Install 4 captive nuts to the rack in locations that line up with the holes (or slots) in the mounting flange on the NTI switch. Then secure the NTI switch to the rack using four 3/16" diameter screws (not provided). Each screw should be of sufficient length to go completely through the NTI mounting flange, rack frame and fully engage all threads in the captive nut. Be sure to tighten all mounting screws securely.

Do not block power supply vents in the NTI switch chassis (if provided) . Be sure to enable adequate airflow in front of and behind the NTI switch.

Attach all cables securely to the switch and where necessary supply adequate means of strain relief for cables.

Rack

		Captive
R NETWORK	1275 Danner Drive Tel: 330-562-7070	Nuts
TECHNOLOGIES	Aurora Ohio 44212 Fax: 330-562-1999
NTI INCORPORATED	www.nti1.com

3/16” Diameter

Screws

Figure 23- Mount the VEEMUX-A to a rack

32

Image 36

Contents SM-8X4-HDA Trademark Table of Contents Table of Figures Default User Name and Passwords IntroductionMaterials CablesFeatures and Functions FrontViewofVEEMUX-AInstallation Connect the SourcesConnect the Devices +L- R+RConnect RS232 Connect to the EthernetPower Up Plug in and power upControl Options Front Panel LCD with Keypad ControlEscape back to the main display Used to enter numbers. # Output user number can be enteredVolume Control Memory FunctionsMenu Button Saving ConnectionsScan Mode RS232 Control Remote ConnectionBaud Rate Unit AddressCommand Protocol Command Good Response Description StringSerTest- RS232 Interface Test Program Main OptionsSetup Options Matrix OperationsEthernet Operations Command Reply Description Telnet InterfaceTelnet 192.168.1.1 NTI AUDIO/HD Video Matrix Switch Enter the Password Web InterfaceVideo Switch Web interface Video SwitchAudio Switch Web interface Audio SwitchSetup Pages Web interface SetupWeb interface Serial Setup Input NamesScan Mode Output NamesUpdate Firmware Web interface Update FirmwareChange Password Update Web ServerHelp LogoutDevice Discovery Tool Device Discovery ToolFeatures And Functions Infrared ControlKeypad LCD DisplayHow To Use The IRT Change the SwitchPower on with SYS, in or OUT keys Power on with 2 key Change Output Port Change Input PortSet Configuration Battery Replacement SpecificationsTroubleshooting the IRT Replace slide cover on unitRS232 Connection Cables Pinout of RS232 port on VEEMUX-APinouts for typical DCE to DTE cable for CPU connection Safety Statements Wiring Schematic of Matrix-Y-1 cableArrows indicate signal direction Pinout for Matrix Y-1 CableRack Mounting Instructions Mount the VEEMUX-A to a rackSpecifications Troubleshooting Warranty InformationProblem Solution