Network Technologies SM-8X4-HDA operation manual Pinout for Matrix Y-1 Cable, Safety Statements

Page 35

NTI AUDIO/HD VIDEO MATRIX SWITCH

Pinout for Matrix Y-1 Cable

Wiring Schematic of Matrix-Y-1 cable

9D Male		9D Female		9D Male
(Unit #1)		(Source)		(Unit #2)
2				3
2				3
3	3				Not connected to
5	5		5		source connector
5	5		5

2 2

7

8 Jumper

1

4Jumpers

Arrows indicate signal direction.

Figure 22- Pinout for Matrix Y-1 Cable

SAFETY STATEMENTS

Grounding

These products have protective earth ground terminals and are built with full attention to consumer safety. There must be an un- interruptible safety earth ground between the main power source and the product's power cord or supplied power cord set.

If ever the possibility exists for the grounding protection to have been reduced in any way, disconnect the power supply until the grounding connection has been fully restored.

Servicing

NTI products are not intended to be serviced in the field and contain no user-serviceable parts. In the event repair is needed, all servicing must be performed by factory trained and authorized service personnel. Only those items specifically identified in this manual (if any) may be adjusted by the user of this product and adjusted only as instructed in this manual.

31

Image 35

Contents SM-8X4-HDA Trademark Table of Contents Table of Figures Cables Default User Name and PasswordsIntroduction MaterialsFrontViewofVEEMUX-A Features and FunctionsConnect the Sources Installation+L- R+R Connect the DevicesConnect to the Ethernet Connect RS232Plug in and power up Power UpOutput user number can be entered Control OptionsFront Panel LCD with Keypad Control Escape back to the main display Used to enter numbers. #Saving Connections Volume ControlMemory Functions Menu ButtonScan Mode Unit Address RS232 ControlRemote Connection Baud RateCommand Good Response Description String Command ProtocolMain Options SerTest- RS232 Interface Test ProgramEthernet Operations Setup OptionsMatrix Operations Telnet 192.168.1.1 Command Reply DescriptionTelnet Interface NTI AUDIO/HD Video Matrix Switch Web Interface Enter the PasswordWeb interface Video Switch Video SwitchWeb interface Audio Switch Audio SwitchWeb interface Setup Setup PagesInput Names Web interface Serial SetupOutput Names Scan ModeWeb interface Update Firmware Update FirmwareLogout Change PasswordUpdate Web Server HelpDevice Discovery Tool Device Discovery ToolLCD Display Features And FunctionsInfrared Control KeypadPower on with SYS, in or OUT keys Power on with 2 key How To Use The IRTChange the Switch Change Input Port Change Output PortSet Configuration Replace slide cover on unit Battery ReplacementSpecifications Troubleshooting the IRTPinouts for typical DCE to DTE cable for CPU connection RS232 Connection CablesPinout of RS232 port on VEEMUX-A Pinout for Matrix Y-1 Cable Safety StatementsWiring Schematic of Matrix-Y-1 cable Arrows indicate signal directionMount the VEEMUX-A to a rack Rack Mounting InstructionsSpecifications Solution TroubleshootingWarranty Information Problem