6.At the ALOM sc> prompt, type the poweron command: sc> poweron
The ALOM software then prompts you to enter a new administrative password.
7.When prompted, enter and then confirm a new administrative password. Once again, the ALOM sc> prompt is displayed.
8.At the ALOM sc> prompt, again type the poweron command: sc> poweron
The poweron command is executed and the sc> prompt is again displayed.
You must complete the next step quickly, before the ALOM
9.Quickly enter the console command: sc> console
After running full diagnostics, the system banner is displayed on the system console device and then the ok prompt is displayed. If your system administrator has configured the network for Solaris JumpStart installation, then installation of the Solaris operating environment will begin at this point. If the network is not so configured, then you must install the operating environment manually, in a later step.
10.Turn the system control keyswitch to the Locked position.
The Locked position disables the Power button, which prevents anyone from accidentally powering off the server.
11.Remove the system key from the system control keyswitch and keep it in a secure place.
If you are using the smaller key, you can leave it in place and use the larger key for the next step.
12.Close and lock the right system door.