2.Set the
ok setenv
Note – For more information about OpenBoot configuration variables, refer to the Netra 440 Server Diagnostics and Troubleshooting Guide
3.To cause the parameter changes to take effect, type:
ok
The system permanently stores the parameter changes and boots automatically when the OpenBoot configuration variable
Note – To store parameter changes, you can also power cycle the system using the front panel Power button.
▼To Disable Automatic System Recovery
1.At the ok prompt, type:
ok setenv
2.To cause the parameter change to take effect, type:
ok
The system permanently stores the parameter change.
Note – To store parameter changes, you can also power cycle the system using the front panel Power button.
After you disable the automatic system recovery (ASR) feature, it is not activated again until you enable it at the system ok prompt.
Chapter 2 Managing RAS Features and System Firmware 45