Installing Uplink Interface Modules (Optional)
An SMD2000-24T does not require installation of an Uplink Interface Module (UIM) for operational purposes. A UIM offers additional upstream network ports to supplement the two T1 uplink ports already provided. You may wish to install a UIM if your network requires an Ethernet uplink connection or if you require an additional E1 or T1 backhaul. The SMD2000-24T supports the following 1-port UIMs only:
UIM-E1
UIM-T1
UIM-10/100
CAUTION:
Disconnect all power sources from the SMD2000 before installing a UIM.
Procedure
To install a UIM:
1.Remove the Chassis Cover. Using a Phillips Screwdriver, remove the eight flathead screws securing the SMD2000-24T chassis cover and set them aside. Carefully lift off the chassis cover and set it aside.
SideRear
TopBottom
Side