Paradyne installation instructions Powering Up the SMD2000-24T

Powering Up the SMD2000-24T

CAUTION:

Turn your DC power source off until you have completed connection of the SMD2000-24T as described below.

Do not operate your SMD2000-24T without a ground connection.

Procedure

To connect the SMD2000-24T to power:

1.Connect a ground wire to the SMD2000-24T. Line up the 2-hole terminal lug of your ground wire with the two holes on the small, unpainted section on the left side of the back of the chassis. Secure the terminal lug to the chassis with two #10-32 screws.

2.Connect the other end of the ground wire to a frame ground. This can vary from location to location, but typically all equipment in a Central Office is grounded to a common copper bus.

3.Select a terminal block. Either terminal block on the back of the SMD2000-24T may be used to power the chassis. Both terminals may be connected if redundancy (backup) is desired.

9