Paradyne SMD2000-24T installation instructions Connecting the Shdsl RJ21 Cable

Page 11

7.Verify the connection. Turn your power source ON. The PWR (power) LED on your SMD2000-24T faceplate will illuminate solid green to indicate that the chassis is receiving power.

Connecting the SHDSL RJ21 Cable

Procedure

To connect the SHDSL cable to the SMD2000-24T RJ21 connector:

1.Configure the SHDSL lines.

No configuration is necessary for the SMD2000-24T to operate at default settings. However, if you wish to run subscriber lines at settings other than the SMD2000-24T defaults, configure the subscriber lines prior to connection. Parameter settings may be changed using the Command Line Interface (CLI), Simple Network Management Protocol (SNMP), or the web-based management system. SHDSL Parameter Defaults on page 15 lists the device defaults. Product Documentation Online on page 3 lists the user interface manuals.

2.Detach the hook-and-loop fastener strap from the RJ21 socket on the front of the chassis and pull it upward, leaving it looped under the connector frame at the top.

11

Image 11
Contents SMD2000-24T 24-Port Shdsl Mini Dslam ContentsSoftware and Firmware License Agreement Product Documentation Online Site Selection Criteria Unpacking and Inspecting the EquipmentProcedure Installing Uplink Interface Modules OptionalUIM Side View Standoffs Tabletop Installation Rack Installation Powering Up the SMD2000-24T Negative Batt Lead Connecting the Shdsl RJ21 Cable Loop Bonded Shdsl Connection Connecting to the Remote Shdsl ModemsSingle Line Shdsl Connection Verifying the ConnectionsConnecting the Uplink Lines Shdsl Defaults Parameter Default SettingsShdsl Parameter Defaults T1 Uplink Parameter DefaultsUsername and Password Defaults Username/Passwords Access System and Management DefaultsUser Access Defaults System and Management Defaults ParameterMemory SMD2000-24T BackupBackup Criteria Data Needed for Backup Example Data StorageShdsl Port Template Template Criteria Data Needed for Backup ExampleSMD2000-24T Template System Clear Reset ButtonSystem Reset LEDs 1 State Indication Additional Information LED IndicatorsLNK LEDs 2 State Indication Additional InformationShdsl LEDs 3 State Indication Additional InformationShdsl RJ21 Pinouts Shdsl RJ21 Pinouts Connector Pins Port Ring, TipPin Assignments T1 RJ48C Pin Assignments Function 10/100BaseT RJ45 PinoutsT1 RJ48C Pin Assignments Ethernet RJ45 Connection PinDB9 to 8-Pin Modular Adapter Pinouts SMD2000-24T Technical Specifications Criteria Technical SpecificationsCanada EMI Notice EMI NoticesActa Customer Information United States EMI NoticeCE Marking Class a ITE Japan NoticeImportant Safety Instructions Warranty, Sales, Service, and Training Information SMD2-A2-GN11-00