Paradyne CSU, DSU, 9126-II, 9128-II manual Table C-9. Dhcp Server Commands 3, Network network-num

C. Router CLI Commands, Codes, and Designations

Table C-9. DHCP Server Commands (3 of 3)

network network-num

[ [ netmask] netmask { prefix-length /} prefix-length]

no network [network-num

[ [netmask] netmask { prefix-length /} prefix-length] ]

Minimum Access Level: Administrator

Command Mode: config-dhcp

Allows you to specify or remove a subnet and subnet mask to a DHCP server pool. The configured subnet and subnet mask will specify the range of IP addresses that will be allocated to clients by the DHCP server. Only one network or subnet may be specified for a server pool.

Example: network 8

network-num– The IP address of the DHCP address pool.

netmask – Specify a network mask that indicates which address bits belong to the network and subnet fields and which bits belong to the host field.

netmask – The network mask for the pool of IP addresses.

prefix-lengthor / – Specify the number of bits in a network mask address that are ones and define the network and subnet fields.

prefix-length– Number of ones bits in a network mask address. Valid range is 1–32.

NOTES:

–If the mask or prefix-length is not specified, the class A, B, or C natural mask is used.

–When the DHCP address range is changed, all binding entries and dynamic routes for the clients configured with the old address range are removed.

9128-A2-GB20-80 September 2002 C-17