Paradyne 7924 manual Connecting to the Network, Connecting Power to the Unit, Procedure

Installing the Unit

Connecting to the Network

"Procedure

1.Connect one end of the supplied 14′twisted-pair network cable into the rear panel HDSL jack. Connect the other end to your HDSL network interface.

NOTE:

Do not use a flat VF network cable, as this may severely degrade the performance of the termination unit. Use only a twisted-pair network cable.

2.Connect a V.35 or DSX-1 interface cable into the appropriate connector on the rear panel. Connect the other end to your V.35 or DSX-1 equipment.

HotWire 7924 V.35-compatible units are not designed to be used at both ends of an HDSL connection.

Connecting Power to the Unit

HDSL 48 VDC DS1

97-15356-01

DSX-1-Compatible HotWire 7924 ± Rear Panel

V.35

HDSL 48 VDC

97-15264

V.35-Compatible HotWire 7924 ± Rear Panel

Plug the power transformer into the appropriate (115 or 230 Vac) power outlet.

Connect the power lead into the ±48 Vdc jack on the rear panel.

To obtain information on the power supplies and power cord adapters available, refer to Warranty, Sales, and Service Information on page A at the beginning of this User's Guide.

2-2 October 1997 7924-A2-GB20-30