Paradyne 7924 manual Worksheets, Overview

Page 42

Worksheets

A

Overview

The worksheets in this appendix show the correct configuration settings based on the types of units (DSX-1-compatible or V.35-compatible) on either end of the HDSL connection. There are two combinations of the two types of units:

HDSX-1-compatible units on both ends

HV.35-compatible unit on the CP end, DSX-1-compatible unit on the CO end

NOTE:

HotWire 7924 V.35-compatible units are not designed for use at both ends of an HDSL connection. If your application requires V.35 equipment at both ends of an HDSL connection, consider using two Hotwire 7925 E1 HDSL termination units. Contact your sales representative for more information.

7924-A2-GB20-30

October 1997

A-1

Image 42

Contents Model 7924 Standalone T1 Hdsl Termination Unit Warranty, Sales, and Service Information Copyright 1997 Paradyne Corporation All rights reservedTrademarks Important Safety Instructions EMI Warnings Contents Customizing V.35-Compatible Units Cable Pin Assignments IiiAbout This Guide Document Purpose and Intended AudienceDocument Summary Product-Related Documents Document Number Document TitleAbout HotWire Model Termination Units HotWire 7924-A1 Models and FeaturesModel Number Features Typical Configurations Campus Network ApplicationsDCS Cellular Network Access User Interface TypesInstalling the Unit Package Checklist for HotWire Model 7924-A1Overview Procedure Connecting to the NetworkConnecting Power to the Unit DSX-1-Compatible HotWire 7924 ± Rear PanelUsing Terminal and Switchpack Modes Choosing an Interface ModeConnecting to a System Terminal Switching Between Terminal and Switchpack Modes Accessing Configuration Options Customizing DSX-1-Compatible UnitsMaking Changes from the Terminal Interface DSX-1-Compatible Units Configuration Options 1 Hdsl Card TypeDSX-1-Compatible Units Configuration Options 2 Making Changes in Switchpack Mode Displaying Switchpack DefinitionsSwitchpack Settings for Line Build OUT Displaying Line Build-Out DefinitionsCustomizing V.35-Compatible Units Customizing V.35-Compatible Units V.35-Compatible Units Configuration Options ± 6 x 64 384 kbps ± No change to rateMaking Changes in Switchpack Mode CO/CP OFF=CP, ON=CO Monitoring the Unit What to MonitorBoard Status Board Status for DSX-1-Compatible UnitBoard Status for V.35-Compatible Unit Performance Statistics Performance Statistics for DSX-1-Compatible Unit Performance Statistics for V.35-Compatible UnitRemote Unit Information Front Panel LEDs DSX-1-Compatible UnitMeaning Compatible Unit Testing Detecting a ProblemUnderstanding Loopback Tests Local Loopbacks Local Loopback, Initiated at the CO UnitRemote Loopbacks Remote Loopback, Initiated at the CO UnitStarting and Stopping Loopbacks Resetting the Unit Worksheets DSX-1-to-DSX-1 Configuration DSX-1-to-V.35 Configuration LANUnframed Operation Time Slot DS0 AssignmentsPayload Rate DSX-1 T1 DS0s Used DSX-1-Compatible Units Configuration Worksheet Compatible Units Configuration WorksheetCable Pin Assignments Terminal Connection Cable Pin AssignmentsHdsl Loop Connection Cable Pin Assignments PinT1 Network Connection Cable Pin Assignments Connection Cable Pin Assignments Direction Code Pin NameFunction Description Switchpacks and Jumpers Jumper Pins Factory-SettingDSX-1-Compatible Units Switchpacks and Jumpers Compatible Units Jumper P8 GL-1 Factory defaultsGlossary COM portReset GL-2Loopback Index IN-1IN-2 Index