Paradyne 7924 manual DSX-1-to-V.35 Configuration, Lan

Worksheets

DSX-1-to-V.35 Configuration

LAN	Cross-campus	Multiplexer
	2- or 4-wire
Router V.35	facility	DSX-1
V.35 Unit		DSX-1
Customer Premises		Central Site
		97-15420

To connect a V.35-compatible unit on the CP side and a DSX-1-compatible unit on the CO side, configure the units as follows. Terminal mode factory defaults are in bold (for Switchpack mode defaults, see Appendix C, Switchpacks and Jumpers).

Configuration	V.35-Compatible Unit	DSX-1-Compatible Unit
Option	(Customer Premises)	(Central Site)
Card Type	CP	CO
Loops Enabled	Dual (Loops A & B) or	Must be same as CP side
	Single (Loop A)
Payload Rate	1 ± 9 (64 ± 1536 kbps)	N/A
	Options 8 (1024 kbps) and 9
	(1536 kbps) are only available
	if both Loops A & B are
	enabled.
Framing	N/A	Use D4, Extended Superframe, or
		Unframed. See Unframed
		Operation on page A-4 before
		selecting Unframed.
T1 Line Encode	N/A	B8ZS or AMI
Line Build-Out	N/A	Enter 5 at the Config command
		prompt. Select from the following
		options:
		1)	0 to 133 ft
		2)	133 to 266 ft
		3)	266 to 399 ft
		4)	399 to 533 ft
		5)	533 to 655 ft

7924-A2-GB20-30 October 1997 A-3