Paradyne 7510 DSU manual Test Status Messages Meaning

Monitoring the DSU

Test Status Messages

The Test Status Messages in the following table appear in the right column of the System and Test Status screen.

Table 4-4. Test Status Messages

Test Status Message	Meaning
No Test Active	Status message, indicating no local, remote, or network test in
	progress.
CSU Loopback Active	A CSU Loopback toward the network is currently active.
Network-init. CSU LB	A CSU Loopback initiated by the network is currently active.
Active
DSU Loopback Active	A DSU Loopback toward the network is currently active.
Network-init. DSU LB	A DSU Loopback initiated by the network is currently active.
Active	H If the network service is 56 kbps, the network loopback is
	non-latching. A non-latching loopback ends when the
	network activation codes stop.
	H If the network service is 64 kbps CC, the network loopback
	is latching. This condition can only occur when the Network
	Interface option Network-initiated DSU Loopback (64K CC)
	is enabled. Refer to Table A-2,Network Interface Options.
V.54-initiated DSU LB	A DSU loopback is active that was initiated by the detection of
Active	a V.54 sequence originated by the remote unit. This condition
	can only occur when V.54 Initiated DSU Loopback is enabled.
	Refer to Table A-2,Network Interface Options, Table A-2.
Local Loopback Active	A local loopback toward the DTE is currently active.
Sending 511 on Port	A 511 test pattern is being sent over the DTE port.
Monitoring 511 on Port	DSU is monitoring a 511 test pattern over the DTE port.
Sending 511 on	A 511 test pattern is being sent over the network interface.
Network
Monitoring 511 on	DSU is monitoring a 511 test pattern on the network interface.
Network
Lamp Test Active	The Lamp Test is active, causing the LEDs on the front panel to
	light.

7510-A2-GB20-10 November 1997 4-5