Paradyne 2600 IP DSLAM manual 17.85 in 453 mm

Page 21

1. Installation

6.Install two wood screws (not provided) at the same height above the floor and 18.75 inches (476.25 mm) apart. Do not completely tighten the screws. Leave them so their heads are about 1/4 inch (6 mm) from the wall.

17.85 in (453 mm)

2600

03-17437

7.Hang the unit from the wood screws to verify that the screws are properly placed. The screws should freely slide into the top of the key slots in the brackets.

Do not fasten the unit to the wall until after it is completely cabled and tested.

2600-A2-GN20-10

January 2004

1-11

Image 21

Contents IP Dslam Copyright 2004 Paradyne Corporation All rights reserved Important Safety Instructions United States EMI Notice Japan January Contents Connectors and Pin Assignments ConfigurationEquipment List Technical Specifications Index LEDsAbout This Guide Document Purpose and Intended AudienceDocument Summary Document Number Document Title Related Product DocumentsOverview InstallationPreparation Installation SiteDSL Ports Cables RequiredUnpacking the Hardware Package ContentsFlat-head screw for attaching 19 mounting brackets to Mounting Configurations Installing the Brackets for Rack MountingMounting Brackets Inch 483 mm Rack Mount Installing the BitStorm 2600 Into a Rack 03-17436 Installing the BitStorm 2600 on a Wall 17.85 in 453 mm Installing the BitStorm 2600 on a Shelf or Desktop Cabling Overview CablingDSL Ports GigE Uplink Port 10/100BaseT Uplink Port Chaining BitStorm 2600s Management Port Console Port Connecting a Terminal or PC to the Console PortConnecting a Modem to the Console Port Alarm Interface Ground Connecting to Power Cabling January LED Locations LEDsLED LED MeaningsConventions Used ConfigurationCLI Commands Function Using the CLIConfigure Management Inband Address Login BitStorm 2600 Startup ProcedureStartup Procedure for Out-of-Band Management Startup Procedure for Inband ManagementUsing the Web Interface System / Users Configuration / Management / SnmpProcedure Figure A-1. BitStorm 2600 IP Front Panel Connectors and Pin AssignmentsDSL Ports and Pots Splitter Connectors Port 3 1000BaseT Connector Port 1 and Port 2 10/100BaseT ConnectorsTable A-4. Port 3 GigE Connector Signal Pin Port 3 GigE SFP ConnectorConsole Port Connector Table A-6. Alarm Connections Signal Direction Contact Alarm ConnectorDescription Model Number Equipment ListEquipment List DSL Technical SpecificationsTable C-1. BitStorm 2600 Technical Specifications 2 Criteria Numerics IndexIN-2 IN-3 IN-4