Paradyne 2600 IP DSLAM manual Using the CLI, CLI Commands Function

4. Configuration

Using the CLI

A command line interface (CLI) can be used to configure and monitor the unit. The CLI is available from a PC or terminal connected to the Console port, or from a Telnet session with the device.

The following commands are available:

Table 4-1. CLI Commands

Command	Function
clear	Clear the system log.
configure	Enter Configuration mode.
copy	Copy from one file to another.
date	Set the time zone and date format.
end	If user is in Administrator mode, shifts to User mode; if user is in
	User mode, positions interface at top of menu tree.
exit	Terminate current session.
firmware	Download or apply new firmware.
paging	Enable or disable paging (more prompt) for this session.
privilege	Enable administrator mode.
restart	Restart a unit.
show	Display configuration, statistics, and status.
technical-support	Display information for contacting technical support.
test	Test the system.

Descriptions of some essential configuration commands follow.

Configure Management Default Gateway Address

The configure management default gateway command specifies the IP address of the next hop router for the management traffic.

configure management default-gateway {ip_address}

Minimum Access Level: Administrator

ip_address – Specifies the IP address of the default gateway for the management ports.

Example:

PDYN# configure management default-gateway 137.90.127.1

4-2 January 2004 2600-A2-GN20-10