Paradyne 6382 manual Sntp

Page 47

3. Using the Web Interface

SNTP

The SNTP screen lets you specify parameters related to SNTP (Simple Network Time Protocol) servers. To use SNTP:

Procedure

1.From the Home screen, click on Advanced and under Advanced, select SNTP. The SNTP screen appears.

2.Enable SNTP and then specify one or more SNTP servers.

3.The Apply button will temporarily save these settings. To make the change permanent, click on Tools and select System Commands. On the System Commands page, click on Save All.

Figure 3-18. SNTP

6382-A2-GB20-00

April 2005

3-23

Image 47

Contents 6382 4-Port Router Copyright 2005 Paradyne Corporation All rights reserved Important Safety Instructions 6382-A2-GB20-00 Canada EMI Notice Japan Notices Contents Contents Index TroubleshootingTerminology Contents April Product-Related Documents About This GuideDocument Purpose and Intended Audience Document SummaryAbout This Guide April Definitions Features of the 6382 4-Port RouterIntroduction Ports and Buttons Back Panel System RequirementsPacking List LED Description Front PanelIntroduction April Overview Hardware Installation PC SetupConnecting the Hardware Hardware Installation Windows XP Configuring Your PC’s IP AddressAssigning an IP Address to your PC Automatically by Dhcp Network Connections in Windows XP TCP/IP Properties in Windows XP WindowsWindows ME Windows 95 Windows NT Logging Into Your Router Using the Web InterfaceQuick Start HomeQuick Start Dhcp Quick Start Static Saving Changes SetupWide Area Network Connection Local Area Network ConnectionConfiguring the WAN New Connection PPPoE Connection SetupPPPoE Connection Setup PPPoA Connection Setup PPPoA Connection Setup Static Connection Setup Static IP Connection Setup Dhcp Connection Setup10. Dhcp Connection Setup Bridged Connection 11. Bridged Connection SetupClip Connection Modify an Existing Connection 12. Clip Connection Setup13. Modem Setup Modem SetupEnable/Disable Dhcp Configuring the LANChanging the Routers IP address 15. Ethernet Switch Ethernet Switch16. Firewall/NAT Services Firewall/NAT ServicesUPnP AdvancedSntp Snmp Port Forwarding IP QoS21. Port Forwarding Netmeeting 22. IP Filters IP FiltersVlan LAN Clients24. Vlan Bridge Filters25. Bridge Filters 26. Multicast MulticastStatic Routing Igmp Snooping28. Static Routing Dynamic Routing29. Dynamic Routing Log Out Access ControlRemote Log System CommandsTools Severity Levels Description 32. Remote Log User Management33. User Management Update GatewayAnalyzer 34. Update Gateway36. Ping Test Ping Test37. Modem Test Modem Test38. Network Statistics Status39. Modem Status Router Is Not Functional TroubleshootingStatus LED is Always Off You Cannot Connect to the RouterLEDs Blink in a Sequential Pattern Status LED Continues to BlinkTerminology What is a Firewall?What is NAT? What is a DMZ?What is a Router? Dhcp IndexIN-2 IN-3 IN-4