Paradyne 6382 manual Snmp

3. Using the Web Interface

SNMP

Use the SNMP (Simple Network Management Protocol) screen to enable and configure the SNMP agent and SNMP trap managers.

The SNMP feature generates a trap whenever the IP address of the router changes (except through the Troubleshooting Management Link). The trap sent contains the following:

„Community (“public”)

„sysObjectID for the router

„IP address of the agent sending the trap

„Time stamp (sysUpTime)

„Serial Number of the router

„IP address of the router

„Interface name

To configure SNMP:

Procedure

1.From the Home screen, click on Advanced and under Advanced, select SNMP. The SNMP screen appears.

2.Enable the SNMP traps, then enter up to five Destination IP Addresses and Community names.

The Apply button will temporarily save these settings. To make the change permanent, click on Tools and select System Commands. On the System Commands page, click on Save All.

Figure 3-19. SNMP

3-24 April 2005 6382-A2-GB20-00