Paradyne 6382 manual LAN Clients, Vlan

Page 52

3. Using the Web Interface

LAN Clients

To add a LAN client, or reserve an IP address for a DHCP client:

Procedure

1.From the Home screen, click on Advanced.

2.Under Advanced, select LAN Clients. If DHCP is used, all DHCP clients are automatically assigned. If a fixed IP address server is on the LAN and you want this server to be visible via the WAN, you must add its IP address. Once the IP address has been added to you can apply Port Forwarding rules to this IP address.

3.The Apply button will temporarily save these settings. To make the change permanent, click on Tools and select System Commands. On the System Commands page, click on Save All.

Figure 3-23. LAN Clients

VLAN

You can use the VLAN (Virtual Local Area Network) screen to match different

VLAN IDs to the LAN ports.

To configure VLANs:

Procedure

1.From the Home screen, click on Advanced.

2.Under Advanced, select VLAN. The VLAN screen appears.

3.Click the appropriate buttons to assign VLAN IDs to the LAN ports.

3-28

April 2005

6382-A2-GB20-00

Image 52
Contents 6382 4-Port Router Copyright 2005 Paradyne Corporation All rights reserved Important Safety Instructions 6382-A2-GB20-00 Canada EMI Notice Japan Notices Contents Contents Terminology TroubleshootingIndex Contents April About This Guide Document Purpose and Intended AudienceDocument Summary Product-Related DocumentsAbout This Guide April Introduction Features of the 6382 4-Port RouterDefinitions System Requirements Ports and Buttons Back PanelLED Description Front Panel Packing ListIntroduction April Connecting the Hardware Hardware Installation PC SetupOverview Hardware Installation Assigning an IP Address to your PC Automatically by Dhcp Configuring Your PC’s IP AddressWindows XP Network Connections in Windows XP Windows TCP/IP Properties in Windows XPWindows ME Windows 95 Windows NT Using the Web Interface Logging Into Your RouterHome Quick StartQuick Start Dhcp Quick Start Static Setup Wide Area Network ConnectionLocal Area Network Connection Saving ChangesConfiguring the WAN PPPoE Connection Setup New ConnectionPPPoE Connection Setup PPPoA Connection Setup PPPoA Connection Setup Static Connection Setup Dhcp Connection Setup Static IP Connection Setup10. Dhcp Connection Setup 11. Bridged Connection Setup Bridged ConnectionClip Connection 12. Clip Connection Setup Modify an Existing ConnectionModem Setup 13. Modem SetupConfiguring the LAN Enable/Disable DhcpChanging the Routers IP address Ethernet Switch 15. Ethernet SwitchFirewall/NAT Services 16. Firewall/NAT ServicesAdvanced UPnPSntp Snmp IP QoS Port Forwarding21. Port Forwarding Netmeeting IP Filters 22. IP FiltersLAN Clients VlanBridge Filters 24. Vlan25. Bridge Filters Multicast 26. MulticastIgmp Snooping Static RoutingDynamic Routing 28. Static Routing29. Dynamic Routing Access Control Log OutTools System CommandsRemote Log Severity Levels Description User Management 32. Remote LogUpdate Gateway 33. User Management34. Update Gateway AnalyzerPing Test 36. Ping TestModem Test 37. Modem TestStatus 38. Network Statistics39. Modem Status Troubleshooting Router Is Not FunctionalYou Cannot Connect to the Router LEDs Blink in a Sequential PatternStatus LED Continues to Blink Status LED is Always OffWhat is a Firewall? What is NAT?What is a DMZ? TerminologyWhat is a Router? Index DhcpIN-2 IN-3 IN-4