Paradyne 6382 manual Dynamic Routing

Page 58

3. Using the Web Interface

3.Specify the Protocol. The protocol is dependent upon the entire network. Most networks support RIP v1. If RIP v1 is selected, routing data will be sent in RIP v1 format. If RIP v2 is selected, routing data will be sent in RIP v2 format using subnet broadcasting. If Rip v1 Compatible is selected, routing data will be sent in RIP v2 format using multicasting.

4.Specify the Direction. This determines the direction that RIP routes will be updated. Selecting In means that the router will only incorporate received RIP information. Selecting Out means that the router will only send out RIP information. Selecting both means that the router will incorporate received RIP information and send out updated RIP information.

5.The Apply button will temporarily save these settings. To make the change permanent, click on Tools and select System Commands. On the System Commands page, click on Save All.

Figure 3-29. Dynamic Routing

3-34

April 2005

6382-A2-GB20-00

Image 58

Contents 6382 4-Port Router Copyright 2005 Paradyne Corporation All rights reserved Important Safety Instructions 6382-A2-GB20-00 Canada EMI Notice Japan Notices Contents Contents Terminology TroubleshootingIndex Contents April Document Summary About This GuideDocument Purpose and Intended Audience Product-Related DocumentsAbout This Guide April Introduction Features of the 6382 4-Port RouterDefinitions System Requirements Ports and Buttons Back PanelLED Description Front Panel Packing ListIntroduction April Connecting the Hardware Hardware Installation PC SetupOverview Hardware Installation Assigning an IP Address to your PC Automatically by Dhcp Configuring Your PC’s IP AddressWindows XP Network Connections in Windows XP Windows TCP/IP Properties in Windows XPWindows ME Windows 95 Windows NT Using the Web Interface Logging Into Your RouterHome Quick StartQuick Start Dhcp Quick Start Static Local Area Network Connection SetupWide Area Network Connection Saving ChangesConfiguring the WAN PPPoE Connection Setup New ConnectionPPPoE Connection Setup PPPoA Connection Setup PPPoA Connection Setup Static Connection Setup Dhcp Connection Setup Static IP Connection Setup10. Dhcp Connection Setup 11. Bridged Connection Setup Bridged ConnectionClip Connection 12. Clip Connection Setup Modify an Existing ConnectionModem Setup 13. Modem SetupConfiguring the LAN Enable/Disable DhcpChanging the Routers IP address Ethernet Switch 15. Ethernet SwitchFirewall/NAT Services 16. Firewall/NAT ServicesAdvanced UPnPSntp Snmp IP QoS Port Forwarding21. Port Forwarding Netmeeting IP Filters 22. IP FiltersLAN Clients VlanBridge Filters 24. Vlan25. Bridge Filters Multicast 26. MulticastIgmp Snooping Static RoutingDynamic Routing 28. Static Routing29. Dynamic Routing Access Control Log OutTools System CommandsRemote Log Severity Levels Description User Management 32. Remote LogUpdate Gateway 33. User Management34. Update Gateway AnalyzerPing Test 36. Ping TestModem Test 37. Modem TestStatus 38. Network Statistics39. Modem Status Troubleshooting Router Is Not FunctionalStatus LED Continues to Blink You Cannot Connect to the RouterLEDs Blink in a Sequential Pattern Status LED is Always OffWhat is a DMZ? What is a Firewall?What is NAT? TerminologyWhat is a Router? Index DhcpIN-2 IN-3 IN-4