Paradyne 6381-A3 manual Configuring Your PC, Windows USB Driver Installation

Page 19

2. Hardware Installation and PC Setup

Configuring Your PC

Before you start to access the router via Ethernet, you must configure your PC's TCP/IP address to be 192.168.1.x, where x is any number between 2 and 254. The subnet mask must be 255.255.255.0. Your router's default IP address is 192.168.1.1.

If you used the Ethernet cable to connect your router and PC, you do not need any specific driver installation and you can skip Windows USB Driver Installation, below. If you used the USB cable on a PC running a Windows operation system, install the provided USB driver.

Windows 95 and Windows NT 4.0 do not support USB without additional software (not included with your router). If USB driver installation fails under those operating systems, contact your service provider.

Windows USB Driver Installation

As soon as you connect the USB cable between your PC and the router, Windows will detect new hardware and the Found New Hardware Wizard will pop up. To install the USB driver:

Procedure

1. Choose "Install from a list or specific location" and click on Next (Figure 2-2).

Figure 2-2. Found New Hardware Wizard

6381-A2-GB23-10

January 2005

2-3

Image 19

Contents 6381-A3 Router Copyright 2005 Paradyne Corporation All rights reserved Important Safety Instructions 6381-A2-GB23-10 Canada EMI Notice Japan Notices Contents Contents Terminology TroubleshootingIndex Contents January Document Purpose and Intended Audience About This GuideDocument Summary Product-Related Documents Introduction Features of the 6381 RouterDefinitions Ports and Buttons Back Panel System RequirementsLED Description Front Panel Packing List Connecting the Hardware Hardware Installation PC SetupOverview Hardware Installation Windows USB Driver Installation Configuring Your PCNew Hardware Installation Options Completing the Found New Hardware Wizard Assigning an IP Address to your PC Automatically by Dhcp Configuring Your PC’s IP AddressWindows XP Network Connections in Windows XP TCP/IP Properties in Windows XP WindowsWindows ME Windows 95 Windows NT Hardware Installation and PC Setup January Logging Into Your Router Using the Web InterfaceQuick Start HomeQuick Start Dhcp Quick Start Static Saving Changes SetupWide Area Network Connection Local Area Network ConnectionConfiguring the WAN New Connection PPPoE Connection SetupPPPoE Connection Setup PPPoA Connection Setup PPPoA Connection Setup Static Connection Setup Static IP Connection Setup Dhcp Connection SetupBridged Connection 10. Dhcp Connection Setup11. Bridged Connection Setup Clip Connection Modify an Existing Connection 12. Clip Connection SetupTsml Modem Setup14. Tsml Connection Configuring the LAN16. LAN Group 1 Configuration Enable/Disable DhcpChanging the Routers IP address 17. Firewall/NAT Services Screen Firewall/NAT ServicesUPnP AdvancedSntp Snmp Port Forwarding IP QoS22. Port Forwarding Netmeeting 23. IP Filters IP FiltersLAN Isolation LAN Clients25. LAN Isolation Bridge Filters26. Bridge Filters 27. Multicast MulticastStatic Routing Igmp Snooping29. Static Routing Dynamic Routing30. Dynamic Routing Log Out Access ControlTools System CommandsRemote Log Severity Levels 2 Description User Management33. Update Gateway Update GatewayPing Test Analyzer35. Ping Test Modem Test37. Product Information StatusUsing the Web Interface January Router Is Not Functional TroubleshootingYou Cannot Connect to the Router Status LED Continues to Blink LEDs Blink in a Sequential PatternStatus LED is Always Off Terminology What is a Firewall?What is NAT? What is a DMZ?What is a Router? Dhcp IndexIN-2 IN-3 IN-4