Paradyne 6381-A3 manual Igmp Snooping, Static Routing

Page 60

3. Using the Web Interface

IGMP Snooping

Use the IGMP Snooping screen to specify whether IGMP Snooping is enabled. When IGMP Snooping is enabled, the router analyzes Internet Group Management Protocol (IGMP) packets to learn multicast group address and port associations.

To enable IGMP Snooping:

1.From the Home screen, click on Advanced.

2.Under Advanced, select IGMP Snooping.

3.Click in the check box to enable snooping.

The Apply button will temporarily save these settings. To make the change permanent, click on Tools and select System Commands. On the System Commands page, click on Save All.

Figure 3-28. IGMP Snooping

Static Routing

If the router is connected to more than one network, you may need to set up a static route between the networks. A static route is a predefined pathway that network information must travel to reach a specific host or network. You can use static routing to allow different IP domain users to access the Internet through the router.

To enable Static Routing:

Procedure

1.From the Home screen, click on Advanced.

2.Under Advanced, select Static Routing.

3-32

January 2005

6381-A2-GB23-10

Image 60
Contents 6381-A3 Router Copyright 2005 Paradyne Corporation All rights reserved Important Safety Instructions 6381-A2-GB23-10 Canada EMI Notice Japan Notices Contents Contents Troubleshooting TerminologyIndex Contents January About This Guide Document Purpose and Intended AudienceDocument Summary Product-Related Documents Features of the 6381 Router IntroductionDefinitions System Requirements Ports and Buttons Back PanelLED Description Front Panel Packing List Hardware Installation PC Setup Connecting the HardwareOverview Hardware Installation Configuring Your PC Windows USB Driver InstallationNew Hardware Installation Options Completing the Found New Hardware Wizard Configuring Your PC’s IP Address Assigning an IP Address to your PC Automatically by DhcpWindows XP Network Connections in Windows XP Windows TCP/IP Properties in Windows XPWindows ME Windows 95 Windows NT Hardware Installation and PC Setup January Using the Web Interface Logging Into Your RouterHome Quick StartQuick Start Dhcp Quick Start Static Setup Wide Area Network ConnectionLocal Area Network Connection Saving ChangesConfiguring the WAN PPPoE Connection Setup New ConnectionPPPoE Connection Setup PPPoA Connection Setup PPPoA Connection Setup Static Connection Setup Dhcp Connection Setup Static IP Connection Setup10. Dhcp Connection Setup Bridged Connection11. Bridged Connection Setup Clip Connection 12. Clip Connection Setup Modify an Existing ConnectionModem Setup TsmlConfiguring the LAN 14. Tsml ConnectionEnable/Disable Dhcp 16. LAN Group 1 ConfigurationChanging the Routers IP address Firewall/NAT Services 17. Firewall/NAT Services ScreenAdvanced UPnPSntp Snmp IP QoS Port Forwarding22. Port Forwarding Netmeeting IP Filters 23. IP FiltersLAN Clients LAN IsolationBridge Filters 25. LAN Isolation26. Bridge Filters Multicast 27. MulticastIgmp Snooping Static RoutingDynamic Routing 29. Static Routing30. Dynamic Routing Access Control Log OutSystem Commands ToolsRemote Log User Management Severity Levels 2 DescriptionUpdate Gateway 33. Update GatewayAnalyzer Ping TestModem Test 35. Ping TestStatus 37. Product InformationUsing the Web Interface January Troubleshooting Router Is Not FunctionalYou Cannot Connect to the Router LEDs Blink in a Sequential Pattern Status LED Continues to BlinkStatus LED is Always Off What is a Firewall? What is NAT?What is a DMZ? TerminologyWhat is a Router? Index DhcpIN-2 IN-3 IN-4