Paradyne 6381-A3 manual TCP/IP Properties in Windows XP

Page 24

2. Hardware Installation and PC Setup

5.In the Internet Protocol (TCP/IP) Properties dialog box, click in the radio button labeled “Use the following IP address” and type 192.168.1.x (where x is any number between 2 and 254) in the IP Address field. Type 255.255.255.0 in the Subnet Mask field.

Figure 2-9. TCP/IP Properties in Windows XP

6. Click on OK twice to confirm your changes, and close the Control Panel.

Windows 2000

To configure the IP address under Windows 2000:

Procedure

1.In the Windows task bar, click on the Start button, point to Settings, and then select Control Panel.

2.Double-click on the Network and Dial-up Connections icon.

3.In the Network and Dial-up Connections window, right-click on the Local Area Connection icon, and then select Properties.

The Local Area Connection Properties dialog box is displayed with a list of currently installed network components. If the list includes Internet Protocol (TCP/IP), the protocol has already been enabled, in which case you can skip to Step 10.

2-8

January 2005

6381-A2-GB23-10

Image 24
Contents 6381-A3 Router Copyright 2005 Paradyne Corporation All rights reserved Important Safety Instructions 6381-A2-GB23-10 Canada EMI Notice Japan Notices Contents Contents Troubleshooting TerminologyIndex Contents January About This Guide Document Purpose and Intended AudienceDocument Summary Product-Related Documents Features of the 6381 Router IntroductionDefinitions System Requirements Ports and Buttons Back PanelLED Description Front Panel Packing List Hardware Installation PC Setup Connecting the HardwareOverview Hardware Installation Configuring Your PC Windows USB Driver InstallationNew Hardware Installation Options Completing the Found New Hardware Wizard Configuring Your PC’s IP Address Assigning an IP Address to your PC Automatically by DhcpWindows XP Network Connections in Windows XP Windows TCP/IP Properties in Windows XPWindows ME Windows 95 Windows NT Hardware Installation and PC Setup January Using the Web Interface Logging Into Your RouterHome Quick StartQuick Start Dhcp Quick Start Static Setup Wide Area Network ConnectionLocal Area Network Connection Saving ChangesConfiguring the WAN PPPoE Connection Setup New ConnectionPPPoE Connection Setup PPPoA Connection Setup PPPoA Connection Setup Static Connection Setup Dhcp Connection Setup Static IP Connection Setup10. Dhcp Connection Setup Bridged Connection11. Bridged Connection Setup Clip Connection 12. Clip Connection Setup Modify an Existing ConnectionModem Setup TsmlConfiguring the LAN 14. Tsml ConnectionEnable/Disable Dhcp 16. LAN Group 1 ConfigurationChanging the Routers IP address Firewall/NAT Services 17. Firewall/NAT Services ScreenAdvanced UPnPSntp Snmp IP QoS Port Forwarding22. Port Forwarding Netmeeting IP Filters 23. IP FiltersLAN Clients LAN IsolationBridge Filters 25. LAN Isolation26. Bridge Filters Multicast 27. MulticastIgmp Snooping Static RoutingDynamic Routing 29. Static Routing30. Dynamic Routing Access Control Log OutSystem Commands ToolsRemote Log User Management Severity Levels 2 DescriptionUpdate Gateway 33. Update GatewayAnalyzer Ping TestModem Test 35. Ping TestStatus 37. Product InformationUsing the Web Interface January Troubleshooting Router Is Not FunctionalYou Cannot Connect to the Router LEDs Blink in a Sequential Pattern Status LED Continues to BlinkStatus LED is Always Off What is a Firewall? What is NAT?What is a DMZ? TerminologyWhat is a Router? Index DhcpIN-2 IN-3 IN-4