Paradyne 6381-A3 manual Enable/Disable Dhcp, LAN Group 1 Configuration

Page 47

3. Using the Web Interface

Enable/Disable DHCP

By default, the router has DHCP server (LAN side) disabled. If you already have a DHCP server running on your network, do not enable the router’s DHCP server.

To enable or disable DHCP:

Procedure

1.From the Home screen, click on Setup.

2.Under LAN Setup, select LAN Configuration. This will bring up the screen shown in Figure 3-15, LAN Configuration Screen.

3.Click on the Configure link in the LAN Group 1 window. The LAN Group 1 Configuration screen appears.

Figure 3-16. LAN Group 1 Configuration

4.The DHCP server is enabled when “Enable DHCP Server” is selected. If you enable it:

—Specify a Start IP address. The Start IP Address is where the DHCP server starts issuing IP addresses. This value must be greater than the router's IP address value. For example, if the router's IP address is 192.168.1.1 (the default) than the Start IP address must be 192.168.1. 2 or higher.

—Specify an End IP address. The End IP Address is the last address the DHCP server can issue. The ending address cannot exceed a subnet limit of 254. The maximum IP address for a router using the default address is

6381-A2-GB23-10

January 2005

3-19

Image 47

Contents 6381-A3 Router Copyright 2005 Paradyne Corporation All rights reserved Important Safety Instructions 6381-A2-GB23-10 Canada EMI Notice Japan Notices Contents Contents Index TroubleshootingTerminology Contents January Document Summary About This GuideDocument Purpose and Intended Audience Product-Related Documents Definitions Features of the 6381 RouterIntroduction Ports and Buttons Back Panel System RequirementsLED Description Front Panel Packing List Overview Hardware Installation PC SetupConnecting the Hardware Hardware Installation Windows USB Driver Installation Configuring Your PCNew Hardware Installation Options Completing the Found New Hardware Wizard Windows XP Configuring Your PC’s IP AddressAssigning an IP Address to your PC Automatically by Dhcp Network Connections in Windows XP TCP/IP Properties in Windows XP WindowsWindows ME Windows 95 Windows NT Hardware Installation and PC Setup January Logging Into Your Router Using the Web InterfaceQuick Start HomeQuick Start Dhcp Quick Start Static Saving Changes SetupWide Area Network Connection Local Area Network ConnectionConfiguring the WAN New Connection PPPoE Connection SetupPPPoE Connection Setup PPPoA Connection Setup PPPoA Connection Setup Static Connection Setup Static IP Connection Setup Dhcp Connection SetupBridged Connection 10. Dhcp Connection Setup11. Bridged Connection Setup Clip Connection Modify an Existing Connection 12. Clip Connection SetupTsml Modem Setup14. Tsml Connection Configuring the LAN16. LAN Group 1 Configuration Enable/Disable DhcpChanging the Routers IP address 17. Firewall/NAT Services Screen Firewall/NAT ServicesUPnP AdvancedSntp Snmp Port Forwarding IP QoS22. Port Forwarding Netmeeting 23. IP Filters IP FiltersLAN Isolation LAN Clients25. LAN Isolation Bridge Filters26. Bridge Filters 27. Multicast MulticastStatic Routing Igmp Snooping29. Static Routing Dynamic Routing30. Dynamic Routing Log Out Access ControlRemote Log System CommandsTools Severity Levels 2 Description User Management33. Update Gateway Update GatewayPing Test Analyzer35. Ping Test Modem Test37. Product Information StatusUsing the Web Interface January You Cannot Connect to the Router TroubleshootingRouter Is Not Functional Status LED is Always Off LEDs Blink in a Sequential PatternStatus LED Continues to Blink Terminology What is a Firewall?What is NAT? What is a DMZ?What is a Router? Dhcp IndexIN-2 IN-3 IN-4