Sub-Zero ICB424FS, ICB430, ICB427R manual Lock Installation, Position the Unit

MODELS ICB424 AND ICB424FS INSTALLATION

LOCK INSTALLATION

IMPORTANT NOTE: If you are adding an accessory lock kit to your Wine Storage unit, it should be installed before you position the unit. Installation instructions are included with the lock kit.

For Model ICB424, the lock is attached to the bottom of the metal door frame. The decora- tive door panel is not involved in the installa- tion or operation of the lock. The catch portion of the lock is attached to the bottom of the appliance cabinet in pre-punched holes. When installing the lock kit, it may be helpful to tip the unit on its back for easier access.

POSITION THE UNIT

IMPORTANT NOTE: If for any reason the Wine Storage unit has been laid on its back or side, you must allow the unit to stand upright for

a minimum of 24 hours before connecting power.

Plug the power supply cord into the 10 amp grounded electrical outlet. With power applied to the appliance, check for lighting and cooling before going any further. Once you are satis- fied that the unit is operating properly, shut off power to the electrical outlet at the circuit breaker and proceed.

Shut off the power to the electrical outlet.

If a home alarm system is to be used with the Wine Storage unit, the lead wires should be threaded into the compressor compartment before you position the unit. See Home Alarm Connections on page 8, for the location of these lead wires. After the unit is in position, the alarm wiring can be completed from the front.

Pre-level the Wine Storage unit before sliding it into position. Leveling cannot be completed with the unit pushed back in the installation opening.

For Model ICB424FS, adust the leveling legs so the top of the unit is no more than 879 mm above the floor. This is to allow the unit to engage the anti-tip bracket properly. Center the Model ICB424FS in front of the anti-tip bracket.

Slide the unit into position, making sure the anti-tip bracket is engaged properly.

IMPORTANT NOTE: When the Wine Storage unit is installed, the anti-tip bracket will be positioned just below the engaging bracket on the unit. It is not necessary to raise the unit up so that it locks into the anti-tip bracket, but the unit must be in alignment with the anti-tip bracket.

The Wine Storage unit provides the best access to its contents when the front surface of the door panel extends out from surround- ing cabinets approximately 6 mm. For Model ICB424FS, if there are no surrounding cabinet surfaces to gauge depth, slide the unit back until it engages the anti-tip bracket.

IMPORTANT NOTE: The floor under the Wine Storage unit must be at the same level as the surrounding finished floor to allow for removal of the unit for servicing.

MODELS

ICB424

ICB424FS

7