MODELS ICB427 AND ICB427R INSTALLATION
LEVEL THE UNIT | MOLDING INSTALLATION |
MODELS
ICB427
Level the unit by turning the front leveling legs clockwise to raise the unit, or counterclockwise to lower it. To assist you in adjusting the front leveling legs up or down, use a standard screwdriver blade and place it in the front leveling leg as shown in illustration 4 below.
The rear leveling legs are adjusted from the front of the base by turning the Phillips head screw. Refer to illustration 5.
IMPORTANT NOTE: The rear leveling legs will only move 2 mm for every 18 revolutions on the Phillips head screw. Do not over torque. Use the lowest torque setting on any power screwdriver. Do not turn the rear leveling legs by hand. Damage will occur if you turn these legs.
To reduce the possibility of the unit tipping forward, the front leveling legs must be in contact with the floor.
The decorative white molding strips for the side and top of Models ICB427 and ICB427R can be snapped into place. The top molding piece must be installed before the side molding can be attached. For installation of the top molding, refer to illustration 6 below. Refer to illustration 7 for side molding installation. For installations where units are side by side, see Finished Wood Side Panels on page 23.
ICB427R
Top Molding |
Illus. 4 | Illus. 5 | Illus. 6 |
Illus. 7
17
