MODELS ICB427 AND ICB427R INSTALLATION
KICKPLATE / GRILLE I N S TA L L AT I O N
MODELS
ICB427
Once the unit is leveled and wiring connec- tions made, the kickplate/grille can be installed.
IMPORTANT NOTE: The kickplate/grille must be removed for servicing. The floor cannot interfere with removal. The louvered section of the kickplate/grille must not be covered so as to prevent air circulation.
For Models ICB427 and ICB427R, there is some adjustment to the mounting assembly so that the kickplate/grille can fit flush with the surrounding area. Refer to illustration 9 below.
IMPORTANT NOTE: The unit must be allowed to have ventilation through the fins of the kick- plate/grille. You may cover the solid area, but do not block the fins. For Model ICB427R, the lower drawer panel may hang in front of the fins, but your baseboard molding must not cover them.
Turn power back on to the electrical outlet.
DOOR PA N E L S
Models ICB427 and ICB427R are available as a glass door (G) or solid door (S) model. Each of these Wine Storage units are set up at the job site as either the stainless steel or integrated design.
Classic stainless steel
The integrated design uses custom wood or other decorative panels and handles provided by the customer.
Model ICB427R requires solid panels on the drawers that may match the door panel, or be complementary. The Model ICB427R stainless steel drawer panel set and stainless steel door panel are ordered and shipped as two items.
The solid door Model ICB427S or ICB427RS— with no glass
Before beginning installation, check for the correct components for the fit and finish desired. The door and drawers (Model ICB427R) require a decorative panel that is a minimum 16 mm thick.
If you have questions, contact your
ICB427R
PANEL
DESIGN
Additional panel design information can be found in the
Illus. 9
19
