Sub-Zero ICB427 Always wear safety glasses and use other, Necessary protective devices or apparel

MODELS

ICB424

ICB424FS

MODELS ICB424 AND ICB424FS INSTALLATION

ANTI - TIP BRACKET INSTALLATION
WOOD FLOOR APPLICATIONS	Installation for Concrete Wedge Anchors:
Use the four #12 x 64 mm wood screws and	1) Drill a 10 mm diameter hole any depth
the four 6 mm flat washers provided. Drill pilot		exceeding the minimum embedment.
holes 5 mm diameter maximum, and be sure		Clean the hole or continue drilling addi-
that the screws penetrate through the flooring		tional depth to accommodate drill fines.
material and into the wall plate a minimum of		Use a carbide drill bit.
19 mm. Be sure that the screws hold tight.	2) Assemble the washer and nut flush with the
Refer to illustration 4 below.
		end of anchor to protect threads. Drive the
		anchor through the material to be fastened
CONCRETE FLOOR APPLICATIONS		until the washer is flush with the surface
Use the two 10 mm x 95 mm concrete wedge		material.
	3) Expand the anchor by tightening the nut
anchors, two #12 x 64 mm wood screws and
		3–5 turns past hand-tight position or to
two 6 mm flat washers provided. Be sure that
		34 newtons of torque.
the anchors and screws hold tight. Refer to
illustration 5 below.
IMPORTANT NOTE: In some installations
the subflooring or finished floor may require	Always wear safety glasses and use other
angling the wood screws used to fasten the	necessary protective devices or apparel
anti-tip bracket to the back wall. Refer to	when installing or working with anchors.
illustrations 4 and 5.	Anchors are not recommended for use in
	lightweight masonry material such as
	block or brick, or for use in new concrete
	which has not had sufficient time to cure.
Make sure that there are no electrical
	The use of core drills is not recommended
wires in the area which the screws could	to drill holes for the anchors.
penetrate.

		610
		mm
	CL	310
310
		mm
mm
Finished Flooring
Underlayment

Wall Plate

Sub Flooring

WOOD FLOOR

		610
		mm
	CL	310
310
		mm
mm
Finished Flooring
Underlayment

Wall Plate

Sub Flooring

38

mmCONCRETE

min FLOOR

Illus. 4 Illus. 5

6