Sub-Zero ICB430, ICB424FS, ICB427R manual Grille Removal, Anti TIP Blocking KIT

MODEL ICB430 INSTALLATION INSTRUCTIONS

MODEL GRILLE REMOVAL ANTI - TIP BLOCKING KIT

ICB430

In order to prevent damage to the grille and to access the power cord, the top grille assembly should be removed prior to moving the unit.

Overlay panel grille: First, remove the inner grille panel assembly as shown in illustration 1 below. Lift up, then pull out at the bottom, pull the top section down and out of the top key slot. Remove the four mounting screws that hold the outer grille panel assembly to the top compartment. Refer to illustration 2.

To prevent the unit from tipping forward and provide a stable installation, the unit must be secured in place with an anti-tip blocking device.

An anti-tip blocking kit (wood block and hardware) is provided with the Model ICB430.

If there is a solid soffit above the unit with clearance between the unit and the soffit of 25

mmor less, you won’t need to block the unit. For installations with clearances of more than 25 mm, you must install the anti-tip blocking kit, to prevent tipover in case several loaded wine shelves are extended at the same time.

Locate and mark two wall studs against the wall where the unit will be installed. Then locate the proper height to clear the unit. The space between the unit top and the bottom of the wood block must not be more than 6 mm.

Position the wood block over the unit and use the screws and ‘L‘ brackets to lock it in place. Make sure the screws extend a minimum of 22

mminto each of the two wall studs. The wood block must be positioned securely and must extend at least 76 mm over the unit. Refer to illustration 4 on page 27.

Using the front and rear leveling legs, raise the unit until it makes contact with the wood block. See Level the Unit on page 28.

Inner Grille	3
Panel Assembly
3
	2
2
1	1

Illus. 1

Panel Grille

Frame

Illus. 2

Soffit

25 mm

Illus. 3

26