Sub-Zero ICB430, ICB424FS, ICB427R manual Overlay Door Panel

MODEL ICB430 INSTALLATION INSTRUCTIONS

MODEL

ICB430

PANEL

DESIGN

Additional panel design information can be found in the Sub-Zero Design Guide. Check our website at subzero.com.

OVERLAY DOOR PANEL

If your customer has chosen an overlay design door and grille panel, the unit will be shipped without handle and hardware. The cabinet manufacturer or designer will provide handle hardware at the job site to match the overall decorating scheme. We recommend larger D-style pulls. The use of small, one-piece knobs is not recommended.

The metal frame on the glass door has numerous mounting holes on each side of the door. This is to accommodate the Sub-Zero accessory handles and provide for easy attach- ment of the handle through the door frame.

If you choose not to use these pre-drilled mounting holes, you must either drill addi- tional holes through the metal frame of the door, or attach the handle through the door panel only.

If you attach through the door panel only, the handle must be attached before the door panel is installed and the handle screws will need to be set into the rear surface of the door panel.

If you choose to drill through the metal door frame, this must be done before the handle holes are located and drilled in the panel.

Illustration 8 shows how this hole passes through the door frame. The hole center is on the small locator groove in the front of the frame. A 6 mm diameter hole is made in the front wall of the extrusion and a 11 mm diameter hole through the rest of the frame.

The wine storage unit door is made with a sealed double wall tempered glass core. The drill must not contact this core when drilling. Be sure the hole is centered on the small groove in the front of the door frame and the drill passes squarely through the frame. If you are inexperi- enced with drilling, fasten the handle from the rear of the door panel only.

Sub-Zero allows a 6 mm space to slide the backing material into place on the door frame. Requirements for proper fit and appearance are; 16 mm minimum overall thickness, 3 mm wide groove between backer portion and overlay portion of panel, finished inside edge and 11 kg maximum weight. See the Wine Storage section of the Sub-Zero Design Guide for additional panel information.

Gasket

11 mm

Diameter

Glass

6 mm

Diameter

Illus. 8

30