Sub-Zero ICB424, ICB430 C H O R the Unit, Do not drill through the model and serial, Number plate

MODEL ICB430 INSTALLATION INSTRUCTIONS

A N C H O R THE UNIT
After door and side panels have been installed,		UNIT ANCHORED TO CABINETRY
the unit has been leveled and door adjustment			First, make sure units have been leveled
completed, anchor the unit to the opening.
			and aligned, and doors adjusted.
This will assure a proper fit and a secure
installation. The Sub-Zero Anchoring Kit (part			Drill three 5 mm holes through both outer
#4200900), available from your Sub-Zero			trims. Refer to illustration 12 below.
dealer, includes the necessary hardware.			Drill a 3 mm pilot hole into the cabinetry.
IMPORTANT NOTE: Be sure to level and
			Install all six Sems.
square the unit before anchoring it.
TWO UNITS ANCHORED TOGETHER
			Do not drill through the model and serial
	Drill three 5,16 mm holes through the
			number plate.
	middle trim of both units.
	Using the Loctite on the screws, install the
	three Chicago screw posts.
	Recheck the units for level.
	Drill three 5 mm holes through both outer
	trims. Refer to illustration 11 below.
	Using a 3 mm drill bit, drill into the cabi-
	netry for a pilot hole.
	Install all six Sems to the cabinetry.

MODEL

ICB430

OPTIONAL COMPONENTS

Optional installa- tion components are available through your Sub-Zero dealer. You can also visit our website at subzero.com.

Illus. 11 Illus. 12

33