Sub-Zero ICB430, ICB424FS, ICB427R manual Overlay Door Panels

MODELS

ICB424

ICB424FS

PANEL

DESIGN

Additional panel design information can be found in the Sub-Zero Design Guide. Check our website at subzero.com.

MODELS ICB424 AND ICB424FS INSTALLATION

OVERLAY DOOR PANELS
OVERLAY GLASS DOOR – MODEL ICB424	IMPORTANT NOTE: After the first three or
Inspect the door panel for the minimum 16 mm	four mounting screws are in place, but not
	completely tightened, close the door and check
thickness, the finished inside edge and the 5 kg
	your panel fit. This is the time to make small
weight limit. See the Wine Storage section of
	adjustments. Once you are satisfied with the
the Sub-Zero Design Guide for additional panel
	appearance, open the door and apply the
information.
	remainder of the screws. Check all screws for
Decide if the handle will be attached through	tightness.
the glass door frame or just through the deco-	The metal frame on the glass door has
rative door panel. If it is just through the door
	numerous mounting holes on each side of the
panel, the handle must be attached first.
	door. This is to accommodate the Sub-Zero
Decorative panels are attached to the Model	accessory handles and provide for easy attach-
ICB424 door using #8 x 16 mm square drive	ment of the handle through the door frame.
screws passing through the door frame from	If you choose not to use the pre-drilled handle
the rear, behind the gasket into the panel. The
	mounting holes, it will be necessary to fasten
door panel is marked for screw locations by
	the handle from the rear of the door panel
the use of ‘tenon centers’, which are temporar-
	only, or drill one or more additional holes
ily inserted into the 6 mm diameter holes in
	through the metal frame of the glass door.
the front of the glass door frame. Refer to illus-
	Illustration 10 on page 11 shows how this
tration 9 on page 11.
With the Wine Storage unit secured in position	hole passes through the door frame. The hole
	center is on the small locator groove in the
and the door closed, the panel is held in the
	front of the frame. A 6 mm diameter hole is
desired position on the door and rapped by
	made in the front wall of the extrusion and
hand from the front, putting center marks on
	an 11 mm diameter hole through the rest
the rear surface of the panel. If the door panel
	of the frame.
is made of such a material that pre-drilling is
needed, all of the mounting holes should be
marked. If not, only enough holes to hold the
panel in place temporarily, are necessary.	The wine storage unit door is made with
The door panel is then lowered from the door	a sealed double wall tempered glass core.
	The drill must not contact this core when
frame, tenon centers removed, the door
	drilling. Be sure the hole is centered on
opened and the screws driven into the panel
	the small groove in the front of the door
through the black tape on the door frame,
	frame and the drill passes squarely
using the center marks to locate the screws.
	through the frame. If you are inexperi-
The screw holes inside the door are hidden	enced with drilling, fasten the handle
	from the rear of the door panel only.
under a cover flap on the door gasket. It is
necessary to lift the flap to insert the screws.
Use as many screws as necessary to hold the
door panel in place properly.

10