Sub-Zero ICB424FS manual Model ICB430 Installation Instructions Lock Installation, Level the Unit

MODEL ICB430 INSTALLATION INSTRUCTIONS

LOCK INSTALLATION

IMPORTANT NOTE: If you are adding an accessory lock kit to your Wine Storage unit, it should be installed before you position the unit. Installation instructions are included with the lock kit.

For Model ICB430, the lock is attached to the bottom of the metal door frame. The decorative door panel is not involved in the installation or operation of the lock. The catch portion of the lock is attached to the bottom of the appliance cabinet in pre-punched holes. When installing the lock kit, it may be helpful to tip the unit on its back for easier access.

POSITION THE UNIT

MODEL

ICB430

If a home alarm system is to be used with the Wine Storage unit, the lead wires should be threaded into the compressor compartment before you position the unit. See Home Alarm Connections on page 28 for the location of these lead wires. After the unit is in position, the alarm wiring can be completed from the front.

Roll the unit into position under the wood block or soffit. Model ICB430 is equipped with rollers so you can easily move the unit into place.

Using the front and rear leveling legs, raise the unit until it makes contact with the wood block.

LEVEL THE UNIT

IMPORTANT NOTE: If for any reason the Wine Storage unit has been laid on its back or side, you must allow the unit to stand upright for a minimum of 24 hours before connecting power.

Plug the power supply cord into the 10 amp grounded electrical outlet. With power applied to the appliance, check for lighting and cooling before going any further. Once you are satis- fied that the unit is operating properly, shut off power to the electrical outlet at the circuit breaker and proceed.

Shut off the power to the electrical outlet.

Once the unit is in position, extend the front leveling legs down to make contact with the floor. Level the unit by turning the front leveling legs clockwise to raise the unit, or counterclock- wise to lower it. The rear height adjustment can be made by turning the 8 mm hex bolt at the front of the base. Refer to illustration 5 below.

IMPORTANT NOTE: Be sure to reference leveling of the unit to the floor and not to surrounding cabinetry.

To reduce the possibility of the unit tipping forward, the front leveling legs must be in contact with the floor.

76

WALL STUD mm

SCREW

WOOD BLOCK

SHROUD

Rear

Adjustment

Front

Leveling Leg

Illus. 4 Illus. 5

27