MODEL ICB430 INSTALLATION INSTRUCTIONS
OVERLAY GRILLE PANEL | MODEL |
| ICB430 |
IMPORTANT NOTE: The size of the overlay panel is critical. It must fit over the door frame.
To install overlay panels, first remove the magnet backed trim molding using a piece of tape to pull it away from the frame and expose the frame screws. The molding will bend at the center so that you can remove it.
Remove the frame by removing the five screws holding it in place. The door channel is now ready to accept the overlay panel. Slide the panel into the frame on the door. With the panel in position, replace the frame end. Be sure the panel is inserted completely into the channel for proper fit and alignment. Next, replace the trim molding by inserting the top, then the bottom into the frame channel. Release the middle and set the magnets.
Install the #8 x 16 mm screws through the back of the glass door frame into the door panel.
IMPORTANT NOTE: Install screws in all the mounting holes in the door frame. The nature of the door panel with a narrow outer rim and no connecting center member requires the support provided by the glass door.
After the door panel installation is complete, apply the cover patches or plugs provided over the holes on the inside surface of the door.
The cover patches or plugs are part of the insulation system on the door of the Wine Storage unit. Be sure to cover all the holes in the door that were used.
A solid panel must not be installed on a glass door unit, as this may cause moisture to form behind the panel.
If you have not already removed the inner and outer grille frame for moving the unit, remove the inner grille panel assembly, see Grille Removal on page 26. Remove the top two corner screws and pull away the top frame. Slide the panel into position in the grille frame. If you are using a grille panel 6 mm or thinner, you will need to install a filler.
Reattach the top frame by reinstalling the two top corner screws. Install the inner grille panel assembly onto the unit.
31
