Sub-Zero ICB430, ICB424FS, ICB427R manual Other Wiring C O N N E C T I O N S

MODELS

ICB427

ICB427R

OPTIONAL COMPONENTS

Optional installa- tion components are available through your Sub-Zero dealer. You can also visit our website at subzero.com.

MODELS ICB427 AND ICB427R INSTALLATION

OTHER WIRING C O N N E C T I O N S
Before the kickplate/grille is installed, all		IMPORTANT NOTE: If you are not responsible
necessary wiring connections in the compres-		for alarm system connection, this information
sor compartment should be completed.		should be supplied to the home security
If the dual installation heater kit (#7007529) is		system contractor.
used with Model ICB427 or ICB427R, the power
supply leads should be connected according to
instructions included with the kit.		The alarm circuit in the unit is intended as
If a home alarm system is to be installed on		a low-voltage, low-current device only. It
the Wine Storage unit, the connections should		should not be used to switch line power.
be made using the logic supplied with the		Any unused terminals should be
alarm specifications. See illustration 8 below		completely insulated and all wires should
for the appliance lead locations, and refer to		be secured away from conductive or
the following for color codes:		moving components.
	Normally open contacts – white with red
	stripe wire
	Normally closed contacts – white with blue
	stripe wire
	Common – gray with white stripe wire

Use the 6 mm spade terminals or wire nuts provided to make the proper wiring connec- tions.

Home Alarm

Connections

Illus. 8

18