Sub-Zero ICB430, ICB424FS manual ICB427R

MODELS ICB427 AND ICB427R INSTALLATION

E L E C T R I C A L R E Q U I R E M E N T S U N PAC K I N G AND M OV I N G

MODELS

ICB427

A220-240 V AC, 50/60 Hz, 10 amp circuit breaker and electrical supply are required. A separate circuit, servicing only this appliance, is required.

The power supply cord has a grounding plug, which must be plugged into a mating ground- ing-type wall receptacle. Follow all National Electrical codes and local codes and ordi- nances when installing the receptacle. For location of the electrical supply, refer to

the Installation Specifications illustration on page 12.

IMPORTANT NOTE: A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation.

Do not use an extension cord. Electrical ground is required on this appliance.

HOME ALARM SYSTEM

If a home alarm system is to be used, refer to Other Wiring Connections on page 18. In addition to operating power, the installer may also be required to supply a home automation system lead to the unit. This is for a low- voltage, low-current signal similar to door and window sensor signals. Common, normally open and normally closed contact configura- tions are provided.

Three 6 mm female spade connectors are located in the compressor compartment and are accessible behind the kickplate/grille on Models ICB427 and ICB427R. A minimum of 914 mm of lead wire should be provided for each contact, exiting the back wall near the electrical outlet.

Uncrate the unit, remove its wood base and discard the shipping bolts that hold the wood base to the bottom of the unit. Remove all packing materials and tape.

IMPORTANT NOTE: Do not discard the kickplate/grille, anti-tip bracket and hardware. These items will be needed for the installation.

All roller-assembly wine shelves should be removed to reduce weight and prevent them from rolling. To remove, pull the shelf out to its full extension, gently and evenly lift up on both sides of the front of the shelf and remove. Reverse the procedure to reinstall the shelf.

Retract the front leveling legs to allow you to move the unit more easily during installation. You will extend the leveling legs when the unit is in its final position to reduce the possibility of the unit tipping forward.

Use an appliance dolly to move the Wine Storage unit. Position the dolly at the side of the unit to prevent damage to finished surfaces.

Before moving the Wine Storage unit into position, protect any finished flooring with appropriate materials.

ICB427R

13