Quatech MPA-200/300, RS-422/485 user manual

Page 4

The information contained in this document cannot be reproduced in any form without the written consent of Quatech, Inc. Likewise, any software programs that might accompany this document can be used only in accordance with any license agreement(s) between the purchaser and Quatech, Inc. Quatech, Inc. reserves the right to change this documentation or the product to which it refers at any time and without notice.

The authors have taken due care in the preparation of this document and every attempt has been made to ensure its accuracy and completeness. In no event will Quatech, Inc. be liable for damages of any kind, incidental or consequential, in regard to or arising out of the performance or form of the materials presented in this document or any software programs that might accompany this document.

Quatech, Inc. encourages feedback about this document. Please send any written comments to the Technical Support department at the address listed on the cover page of this document.

Copyright ©2004 by Quatech Inc.

5675 Hudson Industrial Parkway

Hudson, Ohio 44236

All rights reserved. Printed in the U.S.A.

Quatech Inc, MPA-200/300 Manual

Image 4
Contents MPA-200/300 QUATECH, INCPage Warranty Information Page Compliances Electromagnetic Emissions Table of Contents Quatech Inc., MPA-200/300 Manual Introduction MPA-200 board drawing Hardware Installation IRQ DMA/DRQSCC General Information Accessing the registers RR0 RR1RR2 RR3WR0 WR1WR2 WR3Baud Rate Generator Programming SCC Data Encoding Methods Jumper Block Configurations J4 Interrupt ConfigurationJ5 & J6 Interrupt Level Selection IRQ3 IRQ4 IRQ5 IRQ6 IRQ7IRQ10 IRQ11 IRQ12 IRQ14 IRQ15 J10 Transmit DMA Channel SelectionJ11 Receive DMA Channel Selection J7 Line Driver Control SelectionJ8 Synca to Rlen control Synca Rlen OUTAddressing Base Address = 3F8HPage Interrupts Direct Memory Access Page Reqa Configuration Register D1 -RXSRC, Receive DMA Source D0 -TXSRC, Transmit DMA SourceCommunications Register TM ST Llen Rlen Rcken Tcken Rxden TxdenD1 -RECEIVER Enable D0 -TRANSMITTER EnableDTE / DCE Configuration DTE Configuration Rrclk Rtclk Trxca Tclk TtclkDCE Configuration DCE Clock Configuration External Connections DTR DTR/REQA DSR Dcda +RRCLK Trxc Test Mode CTS Ctsa +DSR DcdaTest Mode Null-Modem Cables Circuit AB Signal Ground Connector Notation Dgnd Circuit CC Data SET Ready DSR Connector Notation +DSR,-DSRConnector Notation +TXD,-TXD Connector Notation +RXD,-RXDConnector Notation +RTCLK,-RTCLK Connector Notation +RRCLK,-RRCLKCircuit CA Request to Send RTS Connector Notation +RTS,-RTS Circuit CB Clear to Send CTS Connector Notation +CTS,-CTSCircuit LL Local Loopback LL Connector Notation Llbk Circuit CD DTE Ready DTR Connector Notation +DTR,-DTRCircuit RL Remote Loopback RL Connector Notation Rlbk Circuit TM Test Mode TM Connector Notation Test Mode Specifications MPA-200/300 Version March