Patton electronic Model 3101RC manual Pre-Installation, Tools and Test Equipment Requirements

Page 15

Model 3101RC Getting Started Guide

2 • Hardware Installation

 

 

Pre-Installation

This section provides safety information to review before installing the Model 3101RC. The information includes required installation tools, safety requirements, and electrostatic discharge protection.

Tools and Test Equipment Requirements

To install and maintain the Model 3101RC, you should have the tools and test equipment listed in table 3.

Table 3. Required Installation Tools and Materials

Item Required

Purpose

 

 

Anti-static wrist strap

Protect the Model 3101RC system from electro-

 

static discharge damage.

 

 

Hand tools

Screw drivers for equipment removal and

 

replacement.

 

 

Wire cutter/stripper

Prepare wires for electrical connections.

 

 

Accessories and hardware kit

Screws, bolts, etc., for securing the equipment on

 

the desired location

 

 

Safety Requirement

To prevent possible serious injury, do not apply power to the Model 3101RC system at the central office or any remote site until you’ve completed all of the installation procedures and connected it to the external facilities. Be cautious when turning on/off the Model 3101RC system power.

Electrostatic Discharge Protection

The terminal cards contain static-sensitive components. When handling them, be sure to wear a properly grounded anti-static wrist strap to prevent the damage from electrostatic discharge. If a wrist strap is not avail- able, hold all cards only by their edges or extractor handles. Do not touch any component or traces on the cards. For future use, store cards in original shipped antistatic bags, or in an approved static-protected bag or container.

To minimize the possible damage from electrostatic discharge, do not install the Model 3101RC in cold, dry places where static electricity can build up. Also, when handling cards, do not touch their rear-edge connector traces. These electrical contact points should be kept free of body oils and other contaminants.

Pre-Installation

15

Image 15
Contents ADSL2/2+ Triple-Play Access Ipdslam Module Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables About this guide AudienceStructure Safety when working with electricity PrecautionsTypographical conventions used in this document General conventionsMouse conventions Model 3101RC Overview Chapter contentsIntroduction Model 3101RC ADSL2/2+ Triple-play Access Ipdslam ModuleApplications FeaturesHardware Installation Electrostatic Discharge Protection Pre-InstallationSafety Requirement Tools and Test Equipment RequirementsConnecting the ADSLx interfaces Hardware InstallationRJ-45 Electrical Trunk Port Connecting the GBE trunk interfaceEthernet Port RJ-45 pin assignment Ethernet Port 10/100 Enet on Trunk CardTxD Console Port ConfigConfiguration CLI Provisioning a Management IP PortConfigure Web GUI Model 3101RC Getting Started Guide3 ConfigurationIP Routes Example Configuration Import/ExportExport export file from Running config to the Tftp server Database configuration menuin the Web GUI Import File Write Download Config To FlashWrite downloaded Config to Flash in progress Load Remote Config to Running Config Get File Import File Load Remote Config to Running ConfigPut Running Config to Remote Tftp Server Put File Export File Put Running Config to Remote Tftp ServerSave Running Config to Flash Write Running Configuration Save Running Config to Flash System ConfigLoad Flash to Running Config Load Configuration Reload Flash to Running ConfigRestore Factory Default Restore Factory DefaultFlash Boot Point Configuration Select Flash Boot Point Configuration Selectfirmware login 172.16.100.41 username Firmware UpdateFTP Get In Progress Firmware update no actionFirmware Write Successful Firmware Write In ProgressOperation Tools and Equipment Requirements Maintenance RequirementDispatching Maintenance Personnel Routine Maintenance3101RC LEDs Controls and LED IndicationConfig TM Controls and LED Indication 3101TM LEDsContacting Patton for assistance Returns for credit Warranty coverageOut-of-warranty service Contact informationReturn for credit policy RMA numbersShipping instructions Appendix a Compliance information EMC Compliance Safety ComplianceCompliance CE Declaration of Conformity