Patton electronic Model 3101RC manual 3101TM LEDs, TM Controls and LED Indication

Page 42

Model 3101RC Getting Started Guide	4 • Operation

3101TM LEDs

Table 8. 3101TM Controls and LED Indication

Front Panel of 3101TM

ETH A

ETH B

25–48

DSL

1–24

READY

Alarm

Model 3101TM

ADSL2+ IpDSLAM

LED	Color	Status	Indication/Condition

READY	Blue	On	Card ready for removal from cPCI chassis.

		Off	Card not ready for removal from cPCI chassis. Do not
			remove card from chassis.

Alarm	Amber	On	Alarm is present on board (mirror of Amber Alarm LED of
			Resource card).

		Off	No alarm.

Interface			Description

Eth A	Small Form-factor Pluggable (SFP) slot 1 for trunk port 1.

Eth B	Small Form-factor Pluggable (SFP) slot 2 for trunk port 2.

DSL	Two RJ-21 connectors for providing 48 ADSL/2/2+ ports.

Controls and LED Indication

42

Image 42

Contents ADSL2/2+ Triple-Play Access Ipdslam Module Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables About this guide AudienceStructure Precautions Safety when working with electricityTypographical conventions used in this document General conventionsMouse conventions Chapter contents Model 3101RC OverviewModel 3101RC ADSL2/2+ Triple-play Access Ipdslam Module IntroductionFeatures ApplicationsHardware Installation Tools and Test Equipment Requirements Pre-InstallationSafety Requirement Electrostatic Discharge ProtectionHardware Installation Connecting the ADSLx interfacesConnecting the GBE trunk interface RJ-45 Electrical Trunk PortEthernet Port 10/100 Enet on Trunk Card Ethernet Port RJ-45 pin assignmentConsole Port Config TxDConﬁguration Provisioning a Management IP Port CLIConﬁgure Model 3101RC Getting Started Guide3 Configuration Web GUIIP Routes Conﬁguration Import/Export ExampleExport export ﬁle from Running conﬁg to the Tftp server Import File Write Download Conﬁg To Flash Database conﬁguration menuin the Web GUIWrite downloaded Conﬁg to Flash in progress Import File Load Remote Conﬁg to Running Conﬁg Load Remote Conﬁg to Running Conﬁg Get FileExport File Put Running Conﬁg to Remote Tftp Server Put Running Conﬁg to Remote Tftp Server Put FileSave Running Conﬁg to Flash System Conﬁg Save Running Conﬁg to Flash Write Running ConﬁgurationReload Flash to Running Conﬁg Load Flash to Running Conﬁg Load ConﬁgurationRestore Factory Default Restore Factory DefaultFlash Boot Point Conﬁguration Select Flash Boot Point Conﬁguration SelectFirmware Update ﬁrmware login 172.16.100.41 usernameFirmware update no action FTP Get In ProgressFirmware Write In Progress Firmware Write SuccessfulOperation Routine Maintenance Maintenance RequirementDispatching Maintenance Personnel Tools and Equipment RequirementsControls and LED Indication 3101RC LEDsConfig 3101TM LEDs TM Controls and LED IndicationContacting Patton for assistance Contact information Warranty coverageOut-of-warranty service Returns for creditReturn for credit policy RMA numbersShipping instructions Appendix a Compliance information CE Declaration of Conformity Safety ComplianceCompliance EMC Compliance