Patton electronic Model 3101RC manual Controls and LED Indication, 3101RC LEDs

Model 3101RC Getting Started Guide 4 • Operation

Controls and LED Indication

The Model 3101 has simple controls and indicators on its front panel. The indicators show the current operat- ing states of various system elements and serve as maintenance aids for local technicians at each site. The remaining controls on the cards are also provided for local system testing and maintenance.

3101RC LEDs

Model 3101RC

ADSL2+ IpDSLAM

Table 7. 3101RC Controls and LED Indication

Front Panel of 3101RC

						DSL CONNECTION
		25	26	27	28	29	30	31	32	33	34	35	36
		37	38	39	40	41	42	43	44	45	46	47	48
RTM	Matrix	1	2	3	4	5	6	7	8	9	10	11	12

Power Alarm 1

2	13	14	15	16	17	18	19	20	21	22	23	24		Ready
Ethernet													10/100 ENET	CONFIG

LED	Color	Status	Indication/Condition
Power	Green	On	This LED is a heartbeat, which shows that the unit is still
			operational. This is done by alternating between BLINK
			and PULSE states and using two cycles of BLINK and then
			one cycle of PULSE.
			Note:
			BLINK: Alternating between OFF and ON; each state
			approximately 250ms.
			Pulse: Like BLINK, but ON for approximately 250ms, OFF
			for 750ms.
		Off	Power is not detected.
Alarm	Amber	On	Alarm is present on board.
		Off	No alarm.
RTM 1 & 2	Green	On	The network facing Ethernet port has Ethernet link.
		Flashing	Traffic is passing.
		Off	The port has no link.
Matrix 1 & 2	Green	On	The 2.16-based mid-plane facing Ethernet port has Ether-
			net link.
		Flashing	Traffic is passing.
		Off	The port has no link.
DSL	Green	On	DSL port is activated, linked, and operating normally
		Off	DSL port is not configured to establish a link.
READY	Blue	On	Card ready for removal from cPCI chassis.
		Off	Card not ready for removal from cPCI chassis. Do not
			remove card from chassis.

Controls and LED Indication 40