Model 3196RC | 3 • Configuring the |
|
|
Introduction
This chapter contains the following procedures that describe configuring the Model 3196RC
•“Configuration
•“Initial configuration through the
•“Using a browser to complete Model 3196RC configuration” on page
-Defining static connections with DS0 mapping (see page 47)
-Configuring the system clocking parameters (see page 45)
-Defining the IP default gateway (see page 44)
-Defining E1 WAN link parameters (see “Configuring line settings and signaling for E1” on page 57) or T1 WAN link parameters (see “Configuring line settings and signaling for T1” on page 60)
•“Saving your configuration” on page
•“Backing up your configuration parameters” on page
•“Completing the installation” on page
Configuration prerequisites
You will need the following to configure the 3196RC
•A PC equipped with the following:
-
-
-Ethernet port
-Web browser (e.g., Netscape Communicator or Microsoft Internet Explorer)
•You will need the following information to configure the Model 3196RC:
-The IP address and subnet mask for the 3196RC’s Ethernet port
-The IP address of the default gateway
-The 3196RC iDSL port number to which each customer premises equipment (CPE) iDSL modem will be connecting.
-A mnemonic naming convention scheme for your iDSL circuit IDs (optional).
-The data rate at which each CPE iDSL will be operating
-The final destination port of the CPE's iDSL modem connection (WAN time slots or another iDSL port, for example,).
Introduction | 36 |