Patton electronic 2621, 2635 manual Dce, Installing the AC power cord

Models 2603, 2621, and 2635 Getting Started Guide 3 • Initial Configuration

Note The IPLink comes with a V.35 cable configured as a tail-circuit. Use this cable to interconnect the IPLink’s V.35 port to a device configured as

a DCE.

2635 IPLink

Power	10/100
		Crossover
	Ethernet
		MDI-X

X.21
WAN
	Interface

	Modem
V.35
Use cable provided
	DCE
with 2635 IPLink

Figure 11. Connecting the 2635 to a DCE device

The serial port on the IPLink Model 2635 is configured as a DCE, it connects directly to a DTE using a stan- dard straight-through V.35 cable.

However, in many applications, the IPLink’s V.35 interface will connect to a DCE (modem or multiplexer), in this situation use the special cable provided with your Model 2635. This DB-25/M35 cable presents the 2635’s V.35 interface as a DTE for direct connection to a DCE (see figure 11).

Installing the AC power cord

The IPLink router comes with an internal or external power supply. This section describes installing the power cord into the IPLink router. Do the following:

The interconnecting cables shall be acceptable for external use and shall be rated for the proper application with respect to volt- age, current, anticipated temperature, flammability, and

CAUTION mechanical serviceability.

Note Do not connect the other end of the power cord to the power outlet at this time.

1.If your unit is equipped with an internal power supply, go to step 2. Otherwise, insert the barrel type con- nector end of the AC power cord into the external power supply connector (see figure 12).

2.Insert the female end of the AC power cord into the internal power supply connector (see figure 12).

Hardware installation 34