Patton electronic 4950-NCE manual Voice signalling, Voice routing-session router, IP services

Page 48

SmartNode 4950-NCE Getting Started Guide	B • Specifications

G.711 Fax-Bypass

Voice signalling

SIPv2

H.323v4

SIP call transfer, redirect

Overlap or en-bloc dialing

DTMF in-band, out-of-band

Configurable progress tones

Voice routing—session router

Local switching (hairpinning)

Least cost routing

Interface huntgroups

Call-Distribution groups

Number blocking

Call Routing Criteria:

•Interface

•Calling/called party number

•Time of day, day of week, date

•ISDN bearer capability

•Various other information elements (IEs) of the ISDN setup

•Wildcard and regular expression matching

Regular expression number manipulation functions:

•Replace numbers

•Add/remove digits

•Pattern matching and replacement

IP services

IPv4 router; RIPv1, v2 (RFC 1058 and 2453)

Programmable static routes

ICMP redirect (RFC 792); Packet fragmentation

DiffServe/ToS set or queue per header bits

Packet Policing discards excess traffic

Voice signalling

48

Image 48

Contents SmartNode 4950-NCE Series Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information Cabling List of Figures List of Tables About this guide AudienceStructure Precautions Impaired functioningSafety when working with electricity Typographical conventions used in this document General observationsGeneral conventions Convention MeaningChapter contents General informationSmartNode 4950-NCE overview SmartNode 4950-NCESN4950-NCE model codes NCE/4E120V/EUISmartNode 4950-NCE rear panel SN4951-NCE model codesWAN ETH 0/0 SmartNode 4950-NCE front panel SN4950/4E120VLED DescriptionApplications overview Application-Multi-service Isdn Internet telephony IAD IntroductionSmartNode installation Planning the installation Network DiagramSite log Network informationInstalling the gateway router Connecting the 10/100/1000Base-T Ethernet LAN and WAN cables Connecting the power supply Initial configuration Connecting the SmartNode to your laptop PC Connecting the SmartNode to your laptop PCConfiguring the desired IP address Factory-default IP settingsLogin Changing the WAN IP addressConnecting the SmartNode to the network Connecting the SmartNode to the networkLoading the configuration optional Bootloader Start BootloaderStart-up with factory configuration Step Command PurposeStep Command Purpose Load a new application image SmartWare via the serial link Xmodem ymodem -bAdditional information Shdsl Basic Configuration Line Setup Configuring PPPoEConfiguration Summary Setting up permanent virtual circuits PVC Using PVC channels in bridged Ethernet modeUsing PVC channels with PPPoE Command PurposeTroubleshooting DSL Connections DiagnosticsContacting Patton for assistance Warranty coverage Contact informationPatton support headquarters in the USA Out-of-warranty service RMA numbersAppendix a Compliance information Compliance Pstn RegulatoryAppendix B Specifications Voice processing signalling dependent Voice connectivityData connectivity Fax and modem supportVoice signalling IP servicesVoice routing-session router Management SystemPhysical Shdsl Daughter Card if applicable Factor SpecsIdentification of the SmartNode devices via Snmp SmartNode Model SysObjectIDSmartNode Model SysObjectID Appendix C Cabling Connecting a serial terminal ConsoleEthernet E1 PRI T1 PRI Appendix D Port pin-outs Pin Signal Console portPRI port Shdsl portPin Appendix E SmartNode 4950-NCE factory configuration Introduction Appendix F End user license agreement End User License Agreement Termination Other licenses