TP-Link TL-WA901ND manual FCC Statement

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents TL-WA901ND Copyright & Trademarks FCC Statement Korea Warning Statements Safety Information Yang Hongliang Product Manager of International Business Product Description 300Mbps Wireless N Access PointContents Factory Defaults Backup & Restore Reboot Password System Log Package Contents Introduction Product OverviewConventions LED Explanation Name Status Indication Main FeaturesAppearance Front PanelRear Panel  Used as Reset button Used as WPS button TL-WA901NDBasic Requirements Hardware InstallationConnecting the Device Before You Begin Note TL-WA901ND300Mbps Wireless N Access Point User Guide Quick Setup Quick Installation GuideQuick Setup TL-WA901ND300Mbps Wireless N Access Point User Guide TL-WA901ND300Mbps Wireless N Access Point User Guide TL-WA901ND300Mbps Wireless N Access Point User Guide TL-WA901ND300Mbps Wireless N Access Point User Guide 12 Network Setting 13 Quick Setup Finish Login Configure the DeviceStatus Device Status Client WPSTo add a new device By PBCMethod One Method Two Add a New Device Method ThreeII. By PIN Click Connect Enter the PINNetwork Wireless Wireless menu Wireless Settings Note TL-WA901ND300Mbps Wireless N Access Point User Guide Configure the Access Point TL-WA901ND300Mbps Wireless N Access Point User Guide Configure the Switch Egress Rule Processing mode of Utag FramesPort  Note 13 Wireless Settings in Repeater mode 14 Wireless Settings in Repeater mode TL-WA901ND300Mbps Wireless N Access Point User Guide 15 Wireless Settings in Bridge with AP mode Wireless Security Access Point TL-WA901ND Multi-SSID Client TL-WA901ND300Mbps Wireless N Access Point User Guide WDS Repeater Universal Repeater 20 Wireless Security RepeaterTL-WA901ND300Mbps Wireless N Access Point User Guide Bridge with AP TL-WA901ND Wireless MAC Filtering To modify or delete an existing entry To set up an entry, follow these instructionsWireless Advanced Throughput Monitor Wireless Statistics27 The Dhcp menu DhcpDhcp Settings Address Reservation Dhcp Clients ListTo delete all Reserved IP addresses Click Clear All System ToolsTo Reserve IP addresses To modify a Reserved IP address31 The System Tools menu SnmpDiagnostic TL-WA901ND300Mbps Wireless N Access Point User Guide Ping Watch Dog 34 Diagnostic ResultsTo upgrade the devices firmware, follow these instructions Firmware UpgradeBackup & Restore Factory DefaultsPassword RebootSystem Log Appendix a Application Example TL-WA901ND TL-WA901ND300Mbps Wireless N Access Point User Guide Wireless Appendix B Factory DefaultsDefault Value Common Default SettingsT2. What can I do if I forget my password? Appendix C TroubleshootingAppendix D Specifications GeneralPhysical and Environment Appendix E Glossary TL-WA901ND300Mbps Wireless N Access Point User Guide
Top Page Image Contents