L2 Managed Switch
■■ Ensure the rack and device are well earthed.
■■ Make sure the power socket has a good contact with the ground. ■■ Keep a reasonable cabling system and avoid induced lightning.
■■ Use the signal SPD (Surge Protective Device\ when wiring outdoor.
Note: For detailed lightning protection measures, please refer to Chapter 3
Lightning Protection.
Installation Site
S
When installing the device on a rack or a flat workbench, please note the following items:
■■ The rack or workbench is flat and stable, and sturdy enough to support the weight of 5.5kg at least.
■■ The rack or workbench has a good ventilation system. The equipment room is well ventilated.
■■ The rack is well grounded. Keep the power socket less than 1.5 meters away from the device.
2222Installation Tools
■■ Phillips screwdriver
■■
Note: These tools are not provided with our product. If needed, please self purchase them.
2222Product Installation
■■ Desktop Installation
To install the device on the desktop, please follow the steps below:
111 Set the device on a flat surface strong enough to support the entire weight of the device with all fittings.
222Remove the adhesive backing papers from the rubber feet.
333 Turnover the device and attach the supplied rubber feet to the recessed areas on the bottom at each corner of the device.
08 
Installation