TP-Link TL-SG3424 manual Logon by Telnet

Page 25

L2 Managed Switch

FFFFFFFFFFFFPort Settings

666Type the User name and Password in the Hyper Terminal window, the factory default value for both of them is admin. The DOS prompt” TP-LINK>” will appear after pressing the Enter button as Figure 5-8 shown. It indicates that you can use the CLI now.

FFFFFFFFFFFFLog in the Switch

■■ Logon by Telnet

To log on to the switch by a Telnet connection, please take the following steps:

111 Make sure the switch and the PC are in the same LAN. 222Click Start→Run to open the Run window.

Configuration 21

Image 25

Contents Installation Guide Copyright & Trademarks FCC Statement Audience Contents Product Overview CCCCCCCCCCCIntroductionAppearance Front PanelLEDs Front panel of TL-SG3424P is shown as the following figure Rear Panel Port FeatureGrounding Terminal Package Contents CCCCCCCCCCCInstallation2222Safety Precautions Electromagnetic Interference ClearnessLightening Protection 2222Product Installation 2222Installation ToolsInstallation Site Desktop InstallationRack Installation Cabling Reasonably CCCCCCCCCCCLightning ProtectionRequirements for Cabling Outdoors Requirements for Cabling IndoorsEthernet Cable Connecting to the Ground via the Power Supply Connecting to the Grounding Bar3333Connect to Ground 3333Equipotential Bonding 3333Use Lightning Arrester Ethernet Port CCCCCCCCCCCConnection4444SFP Port 4444Power On 4444Verify Installation4444Console Port 4444Initialization For TL-SG3210 SwitchConfigure the Switch via GUI CCCCCCCCCCCConfigurationLogon by a Console Port 5555Configure the Switch Using CLISelect the port to connect in -6, and click OK Logon by Telnet Type cmd in the prompt Run window as -10 and click OK FFFFFFFFFFFFFLog in the Switch Qqqq Why does the Power LED work abnormally? AAAAAAAAAAAATroubleshootingAAAAAAAAAAAAHardware Specifications AAAAAAAAAAAATechnical Support L2 Managed Switch Tel +86 755 Mail support@tp-link.com 7106504453 REV2.0.0