TP-Link TL-SG3424 manual Rack Installation

Page 13

L2 Managed Switch

Feet

Bottom of the

Device

Notch

FFFFFFFFFFFFDesktop Installation

■■ Rack Installation

To install the device in an EIA standard-sized, 19-inch rack, follow the instructions described below:

111 Check the grounding and stability of the rack.

222Secure the supplied rack-mounting brackets to each side of the device with supplied screws, as illustrated in the following figure.

Rack- mounting Bracket

Screw

FFFFFFFFFFFFBracket Installation

333 After the brackets are attached to the device, use suitable screws (not provided\ to secure the brackets to the rack, as illustrated in the following figure.

Rack

FFFFFFFFFFFFRack Installation

Caution:

■■ Please set 5~10cm gaps around the device for air circulation. ■■ Please avoid any heavy thing placed on the device.

■■ Please mount devices in sequence from the bottom to top of the rack and ensure a certain clearance between devices for the purpose of heat dissipation.

Installation 09

Image 13

Contents Installation Guide Copyright & Trademarks FCC Statement Audience Contents Product Overview CCCCCCCCCCCIntroductionAppearance Front PanelLEDs Front panel of TL-SG3424P is shown as the following figure Rear Panel Port FeatureGrounding Terminal Package Contents CCCCCCCCCCCInstallation2222Safety Precautions Electromagnetic Interference ClearnessLightening Protection 2222Product Installation 2222Installation ToolsInstallation Site Desktop InstallationRack Installation Cabling Reasonably CCCCCCCCCCCLightning ProtectionRequirements for Cabling Outdoors Requirements for Cabling IndoorsEthernet Cable Connecting to the Ground via the Power Supply Connecting to the Grounding Bar3333Connect to Ground 3333Equipotential Bonding 3333Use Lightning Arrester Ethernet Port CCCCCCCCCCCConnection4444SFP Port 4444Power On 4444Verify Installation4444Console Port 4444Initialization For TL-SG3210 SwitchConfigure the Switch via GUI CCCCCCCCCCCConfigurationLogon by a Console Port 5555Configure the Switch Using CLISelect the port to connect in -6, and click OK Logon by Telnet Type cmd in the prompt Run window as -10 and click OK FFFFFFFFFFFFFLog in the Switch Qqqq Why does the Power LED work abnormally? AAAAAAAAAAAATroubleshootingAAAAAAAAAAAAHardware Specifications AAAAAAAAAAAATechnical Support L2 Managed Switch Tel +86 755 Mail support@tp-link.com 7106504453 REV2.0.0