Polycom 1725-22886-001/A manual Connect the Standard Equipment

Page 11

Connect the Standard Equipment

Connect the Standard Equipment

1

Connect the PowerCam Plus to the Polycom Instructor RP.

1.Place the PowerCam Plus on the video conferencing shelf.

2.Connect one end of the PowerCam Plus cable to the VSX 8000 system as described in the Polycom Setting Up the VSX 8000 System document. The VSX 8000 system is located above the annotation box in the Polycom Instructor RP cabinet.

3.Connect the other end of the PowerCam Plus cable to the PowerCam Plus as described in the Polycom Setting Up the PowerCam Plus document.

Note Do not power on the PowerCam Plus or any of the standard equipment until you are ready to power on the complete system as described in Power on the System on page 10.

2

Connect the Polycom microphone to the Polycom Instructor RP.

1.Place the microphone on a table or other flat surface.

The microphone performs best if you place it correctly. For information about microphone placement, refer to the Polycom Administrator’s Guide for the VSX Series.

2.Find the microphone cable in the back of the Polycom Instructor RP system. One end of the cable is already connected to the system. Connect the other end to the microphone.

You can connect up to three daisy-chained Polycom microphones to the system. If you choose to connect more than one microphone, you will need to order the appropriate cables. To obtain the lengths and part numbers for these cables, refer to the Polycom Administrator’s Guide for the VSX Series.

5

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Setting Up the Polycom Instructor RP Trademark Information About this Guide Setting Up the Polycom Instructor RP Contents Setting Up the Polycom Instructor RP Setting Up the Polycom Instructor RP Unpack and Position the System You should find these accessory boxes Prepare to Install the EquipmentRemove the rear access panel from the cabinet Connect the Standard Equipment Connect the Optional Equipment Connect the Optional Equipment Connect a guest laptop to the Polycom Instructor RP system Complete the Equipment Installation Power on the System Check the Screens and Run the Wizard Calibrate the Annotation Box Calibrate the Annotation Box Setting Up the Polycom Instructor RP Rear Projection Smart Board 3000i Installation Guide Install the Software and Complete the CalibrationUser’s Guide Configure and Use the SystemIf the system It often means Correct it this way TroubleshootingIf the system It often means Correct it this way
Top Page Image Contents