Polycom 1725-22886-001/A manual Connect a guest laptop to the Polycom Instructor RP system

Page 14

Setting Up the Polycom Instructor RP

4

Connect a guest laptop to the Polycom Instructor RP system.

You can connect a guest laptop to the system whenever you want to show others content on the laptop, such as slides for a presentation.

In contrast to the internal computer, the guest laptop can be attached and removed from the system at any time. It does not have the SMART or Polycom Instructor Tools software loaded on it. You cannot use it to annotate or perform other SMART Board or video conferencing functions.

Note You cannot connect both an integrated computer and a guest laptop to the Polycom Instructor RP system at the same time. If you want to connect an integrated computer, refer to the previous step.

To connect a guest laptop to the system:

1.Connect the video (VGA) cable from the laptop to the video connector on the Polycom Instructor RP system.

2.If you want audio from the laptop, connect an audio cable from the laptop to the audio out connector on the Polycom Instructor RP system.

Note If you add a guest laptop to the system at a later time, you may need to recalibrate the touch screen. For information on how to do this, refer to Calibrate the Annotation Box on page 12.

http:// www.polycom.com

5

Connect other optional equipment that you plan to use with the system.

To perform this step, refer to the Polycom Setting Up the VSX 8000 document or to the documentation supplied with the equipment you plan to connect.

You can connect most of the optional equipment that is shown on the Polycom Setting Up the VSX 8000 document. Additional monitors, however, are not supported.

8

Image 14
Contents Setting Up the Polycom Instructor RP Trademark Information About this Guide Setting Up the Polycom Instructor RP Contents Setting Up the Polycom Instructor RP Setting Up the Polycom Instructor RP Unpack and Position the System Prepare to Install the Equipment You should find these accessory boxesRemove the rear access panel from the cabinet Connect the Standard Equipment Connect the Optional Equipment Connect the Optional Equipment Connect a guest laptop to the Polycom Instructor RP system Complete the Equipment Installation Power on the System Check the Screens and Run the Wizard Calibrate the Annotation Box Calibrate the Annotation Box Setting Up the Polycom Instructor RP Install the Software and Complete the Calibration Rear Projection Smart Board 3000i Installation GuideConfigure and Use the System User’s GuideTroubleshooting If the system It often means Correct it this wayIf the system It often means Correct it this way